Loading ...
Loading ...
Loading ...
Aeroscope AS-F1800
12
©
2018 DJI All Rights Reserved.
Modifying the Power Cable
You can use either of the rst two procedures below to extend the power cable if it is not long
enough for your needs. Additionally, you can use the third procedure to convert it into a DC
power cable if necessary.
Procedure 1: Extending the AC Power Cable (New Plug Bracket)
1. Loosen the nut that seals the cable in the waterproof module, and remove the screw on
the top of the module to open it.
2. Cut off the original female plug bracket. Remove the power cable and replace it with a
longer one provided by yourself.
3. Solder the provided plug pins onto the neutral and live wires of the new power cable
(crimping pliers can also be used), then plug the two pins into the female plug bracket
provided in the box.
4. Remove the screw on the ground wire connector of the female plug bracket, then insert
the ground wire of the power cable into the female plug bracket and retighten the screw.
5. Insert the female plug bracket into the waterproof module and tighten the screw. Tighten
the nut to ensure a good seal between the cable and waterproof module.
Live wire
Ground wire
Neutral wire
Live wire
Ground wire
Neutral wire
Live wire
Ground wire
Neutral wire
Live wire
Ground wire
Neutral wire
Live wire
Ground wire
Neutral wire
Live wire
Ground wire
Neutral wire
Loading ...
Loading ...
Loading ...