Dji AEROSCOPE User Manual

Loading ...

Aeroscope AS-F1800

b. If using G16 high-gain antennas, the 2.4GHz antenna should be connected to a 5.8GHz

antenna. Each 5.8GHz antenna has two antenna cable ports. The port marked “OUT” is

for connecting to the Aeroscope unit, and the port marked “IN” is for connecting to the

2.4GHz antenna. Below gure shows the connection conguration and close-up view of

a 2.4GHz antenna.

Connection conguration between

G8 antennas and the stationary unit

(a) The connections between the 2.4GHz antennas and the 5.8GHz antennas in G16

antennas installations. (b) The “IN” and “OUT” ports on a 5.8GHz G16 antenna.

(a) (b)

4. Often, the supplied power cable is too short for the connection between the stationary unit

and the nearest available power outlet. In such cases, a qualied electrical engineer must

extend the initial power cable to complete the connection.

5. After powering on, check the LED indicators with reference to the Indicators section.

6. Download DJI Assistant 2.

from https://www.dji.com/aeroscope/info#downloads

7. Install and run DJI Assistant 2 on a windowns computer (desktop or laptop).

8. Connect the computer and the Aeroscope unit to the same router, or connect them directly

via the Ethernet port.

9. After the Aeroscope stationary unit is found on the DJI Assistant 2 start page, set the

server IP and Port in Network Settings>Server Network Settings.

10. Set the network mode to Wireless if using a wireless dongle. Set to Wired if using an

Ethernet connection. Depending on network provider requirements, set the parameters

manually or set the mode to Auto.

Loading ...

Dji AEROSCOPE Stationary Unit