Loading ...
Loading ...
Loading ...
en Faults and what to do about them.
26
The programme will not
start.
■ Have you pressed the A button?
■ Is Finished in-time selected?
■ Is the door closed?
■ Is the E childproof lock activated? Deactivate it. ~ Page 18
The drum briefly jerks or
judders after the pro-
gramme has started.
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash programme starts.
The water is not draining. ■ Is - - - - selected (Rinse Stop = no final spin)? ~ Page 19
■ Clean the drain pump. ~ Page 22
■ Clean the drain pipe and/or the drain hose.
Water is not visible in the
drum.
Not a fault – the water is below the visible area.
The spin result is not sat-
isfactory.
Laundry is wet/too damp.
■ Not a fault – the unbalanced load detection system has interrupted the spin
cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum.
■ Is Anti-crease (depending on the model) selected?
■ Is the selected speed too low?
The appliance restarts the
spin cycle several times.
Not a fault – the unbalanced load detection system is adjusting an imbalance.
The programme is taking
longer than usual.
■ Not a fault – the unbalanced load detection system is adjusting an imbal-
ance by repeatedly redistributing the laundry.
■ Not a fault – the foam detection system is active – a rinse cycle has been
activated.
The length of the pro-
gramme changes during
the wash cycle.
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown on the display
panel.
Water remaining in the
care product compart-
ment i .
■ Not a fault – the effectiveness of the care product is not affected.
■ Clean the insert if necessary.
Odours in the washing
machine.
Depending on the model, run the ¾ Drum Clean90 °C or i Cottons90 °C
program without laundry.
Add standard washing powder or a detergent that contains bleach.
Note: To prevent foaming, only use half the amount of detergent recommended
by the detergent manufacturer. Do not use detergents intended for woollens or
delicates.
The Å symbol is lit on
the display panel. Foam
may also be leaking from
the detergent drawer.
Have you used too much detergent?
Mix one tablespoon of fabric softener with 1/2 litre of water and pour it into
compartment II (not suitable for outdoor clothing, sportswear or items made
with down).
Use less detergent in the next wash cycle.
Faults Cause/remedy
Loading ...
Loading ...
Loading ...