Loading ...
Loading ...
Loading ...
en Programme default settings
14
wet inside the drum, e.g. for items that
are not to be spun.
- - - - setting: Rinse Stop = no final spin;
the laundry stays in the water after the
final rinse.
You can select "Rinse Stop" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the program has ended.
To resume/end the program
~ Page 19
The maximum speed that can be set
depends on the model and the program
that has been selected.
Finished in-time
(ñ, Λήξη σε ñ)
Before starting the program, you can
preselect the program end time ("Ready
in" time) in hourly increments (h = hour),
up to a maximum of 24 hours.
To do this:
1. Select a program.
The program duration will be
displayed for the selected program,
e.g. 2:30 (hours:minutes).
2. Press the Finished in-time button
repeatedly until the required number
of hours is displayed.
3. Press the A button.
The program will now start.
The selected number of hours (e.g. 8
h) is shown on the display panel and
counts down until the wash program
starts. The duration of the program
will then be displayed.
Note: The program duration is
automatically adjusted when the
program is running.
Certain factors can affect the program
duration, e.g.:
■ Program settings,
■ Detergent dosage (additional rinse
cycles may be required due to
foaming),
■ Load size/type of fabrics (water
absorption differs),
■ Imbalances (e.g. due to fitted
sheets) are eliminated by rotating
the drum briefly several times,
■ Fluctuations in power supply,
■ Water pressure (inflow rate).
Once the program has been started,
you can change the preselected
number of hours as follows:
1. Press the A button.
2. Use the Finished in-time button to
change the number of hours.
3. Press the A button.
Once the program has been started,
you can add more laundry or remove
laundry as required. ~ Page 18
Loading ...
Loading ...
Loading ...