Loading ...
Loading ...
Loading ...
Light Charging status
Flashes yel-
low
Charging process is active.
Flashes red
rapidly
Fault in the charging proc-
ess.
Green Charging process is com-
pleted.
When the vehicle is locked, the indicator
light goes out after some time.
When the vehicle is unlocked, the yellow
indicator light flashes continuously. The
other indicator lights go out after some
time.
Press the button on the vehicle key to
check the charging state. The charging sta-
tus is indicated on the indicator light. In
some cases the vehicle is locked.
Additional messages about the charging sta-
tus, for instance the probable end of charg-
ing or the planned departure time, can be
shown in the instrument cluster or on the
Control Display.
Planning the charging process
General information
The charging process can be adapted to
constraints, for instance the cost of electric-
ity. The vehicle controls the charging proc-
ess in such a way that the charging process
is completed if possible at the departure
time. A departure time must be set for this
purpose, refer to page 264.
The following settings are available:
– Immediate charging.
– Set time window for favorable charging.
– Set the charge current for charging via a
Mode 2 charging cable.
If drive-ready state is switched off, changes
can be made via the Central Information
Display (CID). Settings for the stationary cli-
mate control and charging process are also
accepted for planned departure times.
Setting the charging mode
Via the Central Information Display (CID):
1. "My MINI"
2. "Plan charging/climate control"
3. Select the desired setting:
– "Charge immediately": the charging
process starts as soon as the charg-
ing cable is connected.
– "Charge for departure time": if a de-
parture time is set, a time window
for charging with a favorable elec-
tricity rate can be set.
Setting the time window for favorable-
rate
Via the Central Information Display (CID):
1. "My MINI"
2. "Plan charging/climate control"
3. "Set low cost time slot"
4. Set rate begin.
5. Set rate end.
The vehicle can also start the charging proc-
ess before the selected time window begins
or end it after the selected time window fin-
ishes. The starting point of the charging
process is adjusted so the vehicle can be as
fully charged as possible and, if applicable,
its climate adjusted by the departure time.
Set the charge current for charging
via a Mode 2 charging cable
Depending on the electrical mains, the vehi-
cle must be charged with a different charge
current strength, refer to page 256.
Via the Central Information Display (CID):
Seite 262
MOBILITY Charging the vehicle
262
Online Edition for Part no. 01405A2C458 - II/21
Loading ...
Loading ...
Loading ...