Loading ...
Loading ...
Loading ...
CB / CB-UL, CBF / CBF-UL (E7) 07/2021 Page 22/197
1.14 Measures to prevent accidents
The operator of the chamber must observe the local and national regulations and take precautions to
prevent accidents.
The manufacturer took the following measures to prevent dangers:
• Indications on the type plate
See operating manual chap. 1.6.
• Operating manual
An operating manual is available for each chamber.
• Overtemperature monitoring
The chamber is equipped with a temperature display, which can be read from outside.
The chamber is equipped with an additional safety controller (temperature safety device class 3.1 acc.
to DIN 12880:2007). Visual and audible (buzzer) signals indicate temperature exceeding.
• Safety, measurement, and control equipment
The safety, measuring, and control equipment is easily accessible.
• Electrostatic charge
The interior parts are grounded.
• Non-ionizing radiation
Non-ionizing radiation is not intentionally produced, but released only for technical reasons by electrical
equipment (e.g. power cables). The chamber is equipped with a permanent magnet located behind the
inner panel of the outer chamber door. If persons with active implants (e.g. pacemakers, defibrillators)
keep a sufficient safe distance (distance of field source to implant), an influence of these implants can
be excluded with high probability.
WARNING
Magnets can affect the function of pacemakers and implanted defibrillators.
A pacemaker can be put into test mode and cause discomfort. A defibrillator
may not work anymore.
If you wear such devices, maintain a sufficient safety distance to the chamber door
in the area of the door handle.
Warn wearers of such devices of approaching the chamber door.
• Protection against touchable surfaces
Tested according to EN ISO 13732-1:2008.
• Floors
See operating manual chap. 3.4 for correct installation
• Cleaning
See operating manual chap. 21.
Loading ...
Loading ...
Loading ...