Loading ...
Loading ...
Loading ...
Cleaning the K-Cup® pack Holder Assembly
1. Cleaning the Parts – The K-Cup® pack Holder Assembly can be placed onto the
top shelf of a dishwasher. NOTE: Use low temperature cycles in the dishwasher.
To remove from the Brewer, li the front face of the Brewer.
Grasp the top of the K-Cup® pack Holder with one hand while twist clockwise on
the boom of the K-Cup® pack Holder to unlock it. Aer cleaning, align the
opening of the boom to the rib of the holder and lock the boom with
an-clockwise direcon.
CAUTION: There are sharp needles that puncture the
K-Cup® pack above the K-Cup® pack Holder and in the
boom of the K-Cup® pack Holder. To avoid risk of
injury, do not put your fingers in the K-Cup® pack
Assembly Housing.
Cleaning and Emptying the Reservoir
Storage
Empty the reservoir before storing and take care to ensure that you store your
Brewer in a safe and frost free environment. It is suggested to store your Brewer
in the upright posion. If you store the Brewer in a cold environment, you run
2. Cleaning the Funnel – The Funnel can be removed from the K-Cup® pack Holder
by pulling on it unl it snaps off (fig. 1). The Funnel is dishwasher safe. To replace
it, just snap it back onto the K-Cup® pack Holder Assembly.
3. Cleaning the Exit Needle – The Exit Needle is located on the inside botom of
the K-Cup® pack Holder Assembly. Should a clog arise due to coffee grinds, it can
be cleaned using a clean household tool. Remove K-Cup® pack Holder assembly
and detach Funnel. Insert the household tool into the Needle to loosen the clog
and push it out. The K-Cup® pack Holder is dishwasher safe.
Discard the remaining water by removing the reservoir lid and turning reservoir
upside down over the sink. It is recommended to empty the water reservoir
between uses and use fresh water for each brew. Do not immerse reservoir in
water.
12
Loading ...
Loading ...
Loading ...