Loading ...
Loading ...
Loading ...
||
STARTING AND DRIVING
* Option/accessory.
496
call 00 8000 466 354 65 (or the toll number
+49 6838 907 277)
19
.
Reprogramming individual buttons
To reprogram an individual HomeLink
®
button,
proceed as follows:
1. Press the desired button and hold it
depressed for approx. 20 seconds.
2.
Once the indicator lamp on HomeLink
®
starts to flash slowly, programming can
continue as normal.
Note: If the button to be reprogrammed is
not programmed with a new unit, it will
resume the previously saved program-
ming.
Resetting the HomeLink
®
buttons
It is only possible to reset all of the HomeLink
®
buttons at the same time, not each button
individually. Individual buttons can only be
reprogrammed.
–
Press and hold depressed the outer but-
tons (1 and 3) on HomeLink
®
for approx.
10 seconds.
> When the indicator lamp changes over
from a constant glow to starting to
flash, the buttons are reset and ready to
be reprogrammed.
Related information
•
Using HomeLink
®
* (p. 496)
•
HomeLink
®
* (p. 494)
•
Type approval for HomeLink
®
* (p. 497)
Using HomeLink
®
*
20
When HomeLink
®
is fully programmed it can
be used in place of the separate original
remote controls.
Depress the programmed button. The garage
door, gate, alarm system or similar is activated
(may take a few seconds). If the button is
depressed for more than 20 seconds then the
reprogramming is started. The indicator lamp
illuminates or flashes when the button has
been depressed. Naturally the original remote
controls can still be used in parallel with
HomeLink
®
if required.
NOTE
When the ignition has been switched off,
HomeLink
®
works for at least 7 minutes.
NOTE
HomeLink
®
cannot be used if the car is
locked and the alarm is armed* from the
outside.
19
Note that the toll-free number may not be available depending on operator.
20
Applies to certain markets.
Loading ...
Loading ...
Loading ...