Loading ...
Loading ...
Loading ...
10
Remove the electrical box cover of the operator. NOTE: Your operator may look different than the operator shown.
Insert the TLS1CARD onto either option card receptacle on the logic board.
See the following page if a Timer-to-Close (TTC) is required.
Reconnect power to the operator.
1
2
3
4
Option Card
Receptacles
TLS1CARD
Operator
INSTALLATION
INSTALL THE TLS1CARD
Error Description
Solution
Board Communication Error
Improper Mode Setting
DIP Switch Changed During
Operation
Operator Mode Not Compatible
with the TLS1CARD Mode
Ensure TLS1CARD is seated properly and power cycle the operator.
Refer to manual for proper selection.
Check mode and reset the operator board by moving the selector dial to PROG
and back to desired mode.
Refer to manual for proper mode selection for both the operator board and the
TLS1CARD.
Number of Blinks
1
2
3
4
TLS1CARD ERROR CODES
Loading ...
Loading ...