Loading ...
Loading ...
Loading ...
Heart Rate Monitoring Device
Built in Wireless Heart Rate Receiver
Note: Chest strap transmitter does not come with this unit; contact BODYCRAFT, or your dealer for purchase.
This product is equipped with a built-in receiver for your Heart Rate monitoring. Any Heart Rate
telemetry strap that transmits at 5 kHz is compatible. To get an accurate reading using these devices, you will
need to be within 3’ feet of the console, and a minimum of four feet from others using a heart rate monitoring
device. This BODYCRAFT unit is also equipped with BLE, ANT+, as well as 5K heart rate receivers.
Note: The Transmitter may fluctuate erratically if you are too close too the heart-rate monitoring
equipment or there is other electronics nearby, such as TV & Radio.
While using heart rate control modes, the computer monitors the exact measurement of your pulse. Heart
rate frequency is displayed while the computer continually compares heart rate to the preprogrammed
personal data. The computer adjusts the wattage to maintain heart rate at the preprogrammed level.
How to Wear Your Sensor/ Transmitter (Chest Strap)
1. Buckle one end of the chest strap onto the transmitter.
2. Adjust the band length so that the fit is snug, but not too tight.
3. Buckle the other end of the chest strap onto the transmitter.
4. Center the transmitter on your chest below the pectoral muscle
(breasts).
5. Stretch the transmitter away from your chest and moisten the
conductive electrode strips located next to the buckles with water.
Note: The transmitter is on automatically when being worn. It is off when it is not connected to your
body. However, as moisture may activate the transmitter, thoroughly dry the transmitter to prolong
battery life.
Erratic Heart Rate Readings
Erratic readings on the receiver can be caused by electromagnetic disturbances. If the heart rate
readings appear to be abnormal, check that your product is not within range of other strong
electromagnetic signals.
Common sources are televisions, computers, cars, cell phones, TV antennas and high voltage power
lines (both above and below ground). Please note: Static electricity in clothing or a flapping shirt can
cause electrical interference, so some items of clothing, i.e. manmade fibers, can also be the cause.
Please try wetting the T-shirt in the area where the transmitter is.
Another erratic reading cause can come from the connection point of contact not being warm or moist.
If the battery of the transmitter is running low, the transmission range decreases and may cause
errors similar to the ones listed above in this document.
Any additional medical conditions as described in the previous Pulse Grip Operating Tips, stop exercising
and consult your doctor.
33
Loading ...
Loading ...
Loading ...