Loading ...
Loading ...
Loading ...
Bluetooth
Message Cause Action
Error-10 The power failed
for the
Bluetooth mod-
ule of this unit.
Turn the ignition
switch OFF and
then to ACC or
ON.
If the error mes-
sage is still dis-
played after
performing the
above action,
please contact
your dealer or an
authorized
Pioneer Service
Station.
Pandora
â
Message Cause Action
Error-19 Communication
failed.
Disconnect the
cable from the
iPod. Once the
iPod’s main
menu is dis-
played, reconnect
the iPod and reset
it.
Start up the
Pandora Ap-
plication
from your
Device.
The Pandora ap-
plication has
not started run-
ning yet.
Start up the
Pandora applica-
tion from your
iPhone.
Unable to
save thumb
rating. Try
again later.
Unable to save
thumb rating.
Try again later.
Unable to
save Book-
mark. Try
again later.
Unable to save
Bookmark.
Try again later.
Message Cause Action
Pandora sys-
tem mainte-
nance. Try
again later.
Pandora system
is undergoing
maintenance.
Try again later.
Skip limit
reached.
Skip limit
reached.
Do not exceed the
skip limit.
This version
of the
Pandora Ap-
plication is
not sup-
ported.
This version of
the Pandora ap-
plication is not
supported.
Connect an
iPhone that has a
compatible ver-
sion of the
Pandora applica-
tion installed.
Check Device Device error
message dis-
played in the
Pandora appli-
cation.
Please check your
iPhone.
Pandora is
unable to
play music.
Please see
your Device.
Unable to play
music from
Pandora.
Please check your
iPhone.
Create sta-
tion within
the Pandora
Application
on Device.
No station
found.
Create a station
in the Pandora
application on
your iPhone.
No Active
Station
No station se-
lected.
Select a station.
Message Cause Action
Communica-
tion error oc-
cured. Please
reconnect
your device.
If there is no
ACK after 10 at-
tempted retries
at 750 ms, the
accessory
should assume
that communi-
cation is inter-
rupted and
disconnect
from
PandoraLink.
Please reconnect
your iPhone and
try again.
Device has
not been
registered.
Go to
“Bluetooth
Connection
Menu” to
register.
No Bluetooth
device found.
Follow the in-
structions that ap-
pear on the
screen.
Connection
failed. Press
“Connect” to
retry.
Bluetooth con-
nection or con-
nection to the
Pandora appli-
cation failed.
Follow the in-
structions that ap-
pear on the
screen.
Disconnect-
ed. Press
“Connect” to
reconnect
the device.
Bluetooth con-
nection or con-
nection to the
Pandora appli-
cation lost.
Follow the in-
structions that ap-
pear on the
screen.
Understanding auto EQ error
messages
When correct measurement of the car’s interior
acoustic characteristics is not possible using
auto EQ, an error message may appear on the
display. In such cases, refer to the table below to
see what the problem is and how it may be cor-
rected. After checking, try again.
Message Cause Action
Please con-
nect the mi-
crophone for
measure-
ment. When
finished,
please push
HOME key.
The microphone
is not con-
nected.
Plug the optional
microphone se-
curely into the
jack.
Error. Please
check xxxx
speaker.
The microphone
cannot pick up
the measuring
tone of a speak-
er.
! Confirm that
the speakers are
connected cor-
rectly.
! Correct the
input level setting
of the power amp
connected to the
speakers.
! Plug the micro-
phone securely
into the jack.
Error. Please
check noise.
The surround-
ing noise level
is too high.
! Stop your car in
a place that is
quiet, and switch
off the engine, air
conditioner and
heater.
! Set the micro-
phone correctly.
Error. Please
check bat-
tery.
Power is not
being supplied
from the battery
to this unit.
! Connect the
battery correctly.
! Check the bat-
tery voltage.
Additional information
60
Appendix
Additional information
En
<YRD5376-A/N>60
Loading ...
Loading ...
Loading ...