Loading ...
Loading ...
Loading ...
en
22
Fault Possible cause Remedial action
Warning signal sounds.
Temperature display flashes.
Fig. "/8
Fault - the freezer
compartment is too warm!
Frozen food is at risk.
To switch off the warning signal, press the
temperature setting button, Fig. "/6.
Appliance is open. Close the appliance.
Ventilation openings have
been covered.
Ensure that there is adequate ventilation.
Too much food was placed in
the freezer at once.
Do not exceed max. freezing capacity.
When the fault has been rectified, the
temperature display stops flashing.
The temperature in
the freezer compartment is
too warm.
Appliance opened
frequently.
Do not open the appliance unnecessarily.
The ventilation openings
have been covered.
Remove obstacles.
Large quantities of fresh
food are being frozen.
Do not exceed max. freezing capacity.
The light does not function. The LED light is defective. See chapter “Light (LED)” section.
Appliance was open too
long.
Light is switched off after
approx. 10 min.
When the appliance is closed and opened,
the light is on again.
Controls have reduced
luminosity.
When the appliance is not
used for some time,
the display on the fascia
switches to energy saving
mode.
As soon as the appliance is again used, e.g.
the door is opened, the display switches back
to normal illumination.
Displays do not illuminate. Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
Connect mains plug. Check whether the power
is on, check the fuses.
Appliance is not cooling,
temperature display and light
are lit.
Showroom mode is
switched on.
Hold down temperature selection button
fig. "/2 for 10 seconds until
an acknowledgement signal sounds.
After a short time check whether your
appliance is cooling.
Loading ...
Loading ...
Loading ...