ILve EA101EQ-G User Manual

Loading ...

Connections

EA101EQ-G Rear Panel

SPEAKER OUT

RIGHT LEFT

Red Wire

To Positive

Right Speaker

Red Wire

To Positive

Left Speaker

Speaker Connections

1. Use 16AWG (min) 2-conductor stranded speaker wire for speaker connections.

2. Strip approximately 1/2 to 3/4 of an inch off the ends and twist the strands together so

there are no loose ends that can cause shorts.

3. Ontheamplierrearpanel,turntheclearendsoftheSpeakerTerminalscounterclockwise

so there is enough room between the post and the clear end to feed the stripped wire

through the post hole without damaging the strands.

4. Conrmpolarity.(Redwireto+)

5. Turn the clear ends clockwise to tighten the post and secure the wire.

6. Repeat for left and right speakers, + and -.

7. Conrmconnectionandpolarity.

8. Connect the speaker wires to the appropriate + and - terminals on the speakers.

9. Conrmconnection,polarityandposition.

NOTE: IftheSpeakerOutsensesashort,theamplierwillenterprotectmodeand‘Protect’

will appear in the front panel display. In protect mode, the audio amp will be shut down, but

the logic and control will remain on. Source select and volume changes will be shown in the

display, but there will be no output from the amp and ‘Protect’ will again be shown in the

display after changes are made.

Toresettheamp,powercycletheamp(unplugtheamplierfromthewalljackfor5seconds

and then plug it back in). If the amp does not return to normal operation, please contact

ELAC at 714.252.8843 or at [email protected].

Other Connections

For information on connecting audio devices to the EA101EQ-G, see section: Rear Panel

Features.

For information regarding Bluetooth audio streaming, see section: Bluetooth.

Figure 5 EA101EQ-G Speaker Connections

Loading ...

EA101EQ-G ILve Audio