User Manual Dreame V11 Cordless Stick Vacuum Cleaner

Dreame V11 Cordless Stick Vacuum Cleaner - Use Manual - Use Guide PDF.
Documents: Go to download!
  • Owner's manual - (English, French, German, Arabic, Italian, Russian, Thai)

file thumbnail

User Manual

Product Overview

Part Names

Accessories

Charging

Note:

  • Fully charge the vacuum cleaner before using it for the first time. This will take about 4 hours.
  • Vacuum cleaner cannot be used while charging.
  • Vacuuming at turbo mode for a prolonged period will cause the battery to heat up, which increases charging time. Allow the vacuum cleaner to cool down for 30 minutes before charging it.

Battery Status Indicator

Note:
Once the vacuum cleaner is fully charged, the indicator will turn off after 5 minutes, and the vacuum cleaner will enter the energy-saving mode.

How to Use

Function Introduction of Display Screen

Note: If you need to pay attention to any abnormality during the use of the product, the screen will push a prompt message. You should follow the instructions on the screen to keep the performance normal.

Language Setup

You may set the display prompt language (Simplified English is the default when you start the machine) by the following methods as you need.

Note: If there is no operation for more than 5 seconds, it will automatically exit from the language setting interface, and the display information will be off.

Cleaning Mode

There are two working modes for the vacuum cleaner, which can be selected according to your own needs.

Mode 1: Discontinuous Cleaning Mode

Press and hold the switch of the vacuum cleaner to start working, and release it to stop immediately.

Mode 2: Continuous Cleaning Mode (Electronic lock)

In standby mode, click the electronic lock key to switch to Continuous Cleaning Mode, and then briefly press the switch to make the vacuum cleaner in Continuous Cleaning Mode.

Use the electronic lock to free your finger and avoid finger fatigue caused by holding the switch.

Note:

  • In this mode, briefly press the switch to suspend the operation or start again, and the working mode of the vacuum cleaner will not change.
  • Click the electronic lock again to quit the Continuous Cleaning Mode.

Using Different Attachments

Soft Roller Nozzle

Suitable for vacuuming wood, tile, marble, and other hard floor surfaces as well as for vacuuming up larger pieces of dirt and debris.

The soft roller nozzle can also be directly attached to the vacuum cleaner.

Mini-Motorized Nozzle

Strong vibrations yield deep cleaning action for removing mites and dust from mattresses and fabric surfaces.

2-in-1 Brush Nozzle

Suitable for vacuuming up dust and mites on beds, sofas, and other furniture fabric.

2-in-1 Crevice Nozzle

Suitable for vacuuming cracks, corners of doors and windows, stairs, and other hard-to-reach places.

Extension Hose

Use for hard-to-reach corner cleaning.

Note:

  • If any rotating part becomes stuck, the vacuum cleaner may turn off automatically. Remove any trapped foreign objects, then resume use.
  • The vacuum cleaner will automatically shut off if its motor enters overheat protection mode. Wait until the motor's temperature returns to normal before resuming use.

If you need to pay attention to any abnormality during the use of the product, the screen will push a prompt message. You should follow the instructions on the screen to keep the performance normal.

Specifications

This product contains batteries that can only be replaced by qualified technicians or after-sales service.

This product contains batteries that are non-replaceable.

WEEE Information

All products bearing this symbol are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) which should not be mixed with unsorted household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a designated collection point for the recycling of waste electrical and electronic equipment, appointed by the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences to the environment and human health. Please contact the installer or local authorities for more information about the location as well as terms and conditions of such collection points.

FAQ

If the vacuum cleaner is not working properly, please refer to the troubleshooting table below.

Errors Possible Causes Solutions
Vacuum cleaner does not work Vacuum cleaner is out of battery or low on power Fully charge the vacuum cleaner, then resume use
Overheat protection mode triggered by a blockage Wait until the vacuum cleaner cools down, then reactivate it
Suction opening or airway passage is blocked Clear any blockages from suction opening or airway passage
Weak suction force Dust compartment is full and/or HEPA filter assembly is clogged Empty the dust compartment and clean the HEPA filter assembly
Attachment is blocked Clear any blockages in the attachment
Motor makes a strange noise Main suction opening or extension rod is blocked Clear any blockages in main suction opening or extension rod
The first indicator is red after turning on the vacuum cleaner Battery is damaged

Please contact the after-sales service department for maintenance

The first indicator blinks red after turning on the vacuum cleaner Power adapter is incompatible Only use the original power adapterto charge the vacuum cleaner
Battery indicator does not light up while charging The adapter is not connected to the vacuum cleaner Make sure the power adapter is plugged in properly
The battery is fully charged and goes into sleep mode Vacuum cleaner can be used normally
If the problem persists after ruling out the above two possibilities

Please contact the after- sales service department for maintenance

Charge slowly Battery temperature is too low or too high Wait until the battery's temperature normalizes, then resume use



See other models: T20 T30.

Dreame V11 | Pages: 54 | File type: PDF | Filename: 37955390_v11.pdf | Size: 8.76 MB | Language: English, French, German, Arabic, Italian, Russian, Thai

Download User Manual

Product Infomation and Reviews - V11 photo

V11 Photo

T: @manualsFile

https://manualsFile.com

Dreame V11 Questions and Answers

Find answers or Ask a question.
  • Total questions: 1
  • Questions unAnswered : 1

#1 How long does Dreame V11 take to fully charge the battery pack?
It takes 4 hours and will use 0.1 KWH to fully charge the battery pack.30*0.8*4 = 96 Ah = 0.096 KW = 0.096 KWH30 refers to voltage, 0.8 refers to current, and 4 refers to charging time

#2 Why sometimes the vacuum works less than 10mins after fully charged?
The 10-min runtime only refers to continuous operation on floor surface. When operating on rough surfaces or with frequent start/stop, energy consumption increases like a car, which may result in less than 10mins’ working time at Ultra mode.

#3 Could the system memorize the working mode?
Yes. The working mode will be memorized after the product is turned off.