Loading ...
Loading ...
Loading ...
How to Set the Door Alarm.
You don’t have to set the visual
alarm. As long as either door is
open, the red DOOR OPEN
signal light flashes.
If the signal light on the
DOOR ALARM pad is glowing,
the beeper alarm is set.
If it’s
not, touch
thepadtoturniton.
If either door is open for more than 30 seconds, a
recurring beep sounds.
The light goes out and the beeping stops when you
close the door.
There are times when you’ll want the Door Alarm
beeper turned off. When you’re rearranging a lot of
food, for example. Just touch the pad. The light will
go out and the beeping will stop.
Deactivating the Door Alarm beeper does not turn the
red DOOR OPEN light off—it keeps flashing until the
door is closed.
Why the Red Warm Temperature Light Glows.
At first, it’s probably because From then on, the red light will glow whenever
your newly installed refrigerator temperatures inside get too high for proper food storage.
hasn’t completely cooled down If this happens, open the doors only when absolutely
yet. Wait a few hours
for
it to cool,
necessary, and close them as quickly as possible.
and then the light will
go
out.
As soon as inside temperatures return to normal, the
light goes out.
If
the WARM TEMP light reappears and stays on for
longer than 4 hours, call for service.
How the Electronic Monitor and Diagnostic
The word NORMAL is lighted
except when a failure has
been detected.
The SYSTEM CHECK-RESET
pad has two functions:
System Works.
1. You can touch the SYSTEM CHECK-RESET pad
and get
a
review of the electronic diagnostic codes
in order of their priority.
2. You can touch the SYSTEM CHECK-RESET pad
to erase three flashing codes immediately and two
codes after the condition that caused them to flash
has been corrected (see the next page).
(continued next
page)
7
Loading ...
Loading ...
Loading ...