Loading ...
Loading ...
Loading ...
INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
36
ArtNo.102-0005 - Gas regulator types
Type 1 Type 2
Replace the rings on the burners. Screw in the hexagon
headed venturi to make tting the burners easier. Do not
tighten yet.
When all the burner bases and venturis have been tted
tighten the venturi nuts.
Valve Adjustment
Removing the Control Panel
Pull o all the control knobs.
Open both oven doors and remove the xing screws
underneath the control panel.
On single oven models the cooling guide, below the control
panel, and its 4 xing screws must be removed to gain access
to the control panel xings.
Remove the 3 xing screws at the top of the control panel.
Pull the control panel forward. Taking care not to damage it,
by protecting it with cloth for example, rest it on the open
oven doors.
Bypass Screw Adjustment
Turn the bypass screw on each control clockwise to the stop
(Fig.8.2).
See Table 8.2 for the correct size.
Reassemble
Replace the control panel and secure with xing screws.
Ret the control panel and cooling guide where tted
If you have lifted the maintop, carefully lower it onto the
range. The burners are protected against the burner ames
going out by Flame Supervision Devices (FSD’s).
Take care when lowering the maintop to locate the FSD
sensor probes (Fig.8.3) in their holes in the cook top and the
burner bases.
Gas Regulator
Note: To avoid exterior damage to the storage drawer. Ensure
a soft cushioned mat is placed on the oor and covers the
width and depth of the storage drawer.
Slide the drawer out until it stops.
Unscrew the two fasteners and remove the screw washers
from either side of the storage drawer runner brackets
(Fig.8.4).
For safety reasons slide the inner side rails back into the
cavity.
The regulator is now accessible.
The regulator may be one of two types (Fig.8.5).
Natural Gas and
Propane Gas
Cooktop Bypass
Center burner
49
Large burners
38
Right front burner
31
Table 8.2
ArtNo.0102-0011 - Screwing
the control valve bypass screw
Fig.8.2
Fig.8.3
Fig.8.4
Fig.8.5
Loading ...
Loading ...
Loading ...