Loading ...
Loading ...
Loading ...
INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
24
Cooker
Outer stability
bracket
Floor
Wall
3 mm min
Typical wall mounting
Outer anti-tip
bracket
Range
1/8” (3mm) min
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability bracket
Floor
3 mm min
Typical oor mounting
Anti-tip bracket
Range
1/8” (3mm) min
A
B
A
B
ArtNo.280-0029 - Flue Grill
ArtNo.280-0030 - Fixing Flue Grill
ArtNo.280-0031 - Flue Extension Fixing
A – Outer anti-tip bracket, B – Inner anti-tip bracket
Installing the Flue Grille
The ue grille is packed separately (Fig.7.7).
The larger of the holes along the sides are for screwdriver
access and should face to the rear. Use the screws and nuts
supplied to hold the grille in place (Fig.7.8).
Clip the exible extensions of the oven ues to the ue grille
using the clips provided inside the ue grille (Fig.7.9).
Leveling
It is recommended that you use a spirit level on a shelf in one
of the ovens to check for level.
Place the range in its intended position, taking care not to
twist it within the gap between the kitchen units as damage
may occur to the range or the units.
The front feet and rear rollers can be adjusted to level the
range. To adjust the height of the rear of the range turn the
adjusting nuts at the front bottom corners of the range. To set
the front, turn the feet bases to raise or lower.
Anti-Tip Device
WARNING: The range must be secured by the Anti-
Tip bracket supplied. Unless properly installed, the
range could be tipped by leaning on the door. Injury
might result from spilled hot liquids or from the
range itself.
When tting an anti-tip device please refer to the instructions
supplied with the device for further details on tting.
Note: The range must be set to the correct height and leveled
before the anti-tip bracket is installed.
Floor Fixing
Using the screw supplied, assemble the anti-tip bracket base
and anti-tip bracket extension (Fig.7.10).
Using suitable screws and xings, attach the assembled anti-
tip bracket to the oor to give a sucient engagement into
the back of the range.
Adjust and lock the inner anti-tip bracket to give a
1
/
8
” (3mm)
clearance above the engagement edge in the back of the
range (Fig.7.11).
Wall Fixing
Where oor xing is impractical and provided that the outer
anti-tip bracket can be attached to a solid wall, the anti-tip
device may be attached to a wall (Fig.7.12). Make sure to use
suitable screws and xings.
Fig.7.7
Fig.7.8 Fig.7.9
Fig.7.10
Fig.7.11
Fig.7.12
Loading ...
Loading ...
Loading ...