Loading ...
Loading ...
Loading ...
- 22 -
C. Connect Lead Wires
1) Before proceeding to this step, be sure the device is completely
turned OFF.
2) Insert the lead wires into the output sockets located on the top
of the device.
3) Holding the insulated portion of the connector, push the plug end
of the wire into one of the sockets (see g. 1); one or two sets
of wires may be used.
4) This device has two output receptacles controlled by Channel 1
and Channel 2 at the top of the unit. You may choose to use one
channel with one pair of lead wires or both channels with two pairs
of lead wires. Using both channels gives the user the advantage of
stimulating two different areas at the same time.
NOTE: If you use only one Channel, only plug in 1 lead wire
at the top of the unit
D. Turn on Device
Open the protective case located on the top of the device. Turn the dial
for the corresponding channel, clockwise until it clicks and a beep is
heard. DO NOT turn any further as this will increase the intensity. Be
sure to set other parameters rst (if applicable) and then you can turn
each channel up slowly to increase intensity to a strong but comfortable
stimulation.
(fig. 1)
Loading ...
Loading ...
Loading ...