Loading ...
Loading ...
Loading ...
- 17 -
4.2 Technical Specifications (TENS)
Modes (5) B (Burst), N (Normal), M (Modulation), SD1 (Strength Duration 1), SD2
(Strength Duration 2)
Burst Mode
(B)
Burst Rate: Adjustable, 0.5 – 5Hz
Pulse Width: Adjustable, 50 – 300us
Frequency: Fixed = 100 Hz
Normal
Mode (N)
The Pulse Rate and Pulse Width are adjustable. It generates continuous
stimulation based on the setting value.
Modulation
Mode (M)
The Pulse Rate and the Pulse Width modulate automatically in a varied
cycle pattern. The Pulse Width is decreased by 50% from its original
setting in 0.5 seconds, then the Pulse Rate is decreased by 50% from its
original setting in 0.5 seconds. Total cycle time is 1 second. In this mode,
Pulse Rate and Pulse Width are fully adjustable.
SD1 Mode
(SD1)
The intensity and Pulse Width automatically modulate within a 40% range.
The intensity will increase by 40% in 5 seconds while the Pulse Width will
decrease by 40% in the next 5 seconds and vice-versa. The total cycle
time is 10 seconds. Pulse Rate and Pulse Width are fully adjustable.
SD2 Mode
(SD2)
The intensity and Pulse Width automatically modulate within a 70% range.
The intensity will increase by 70% in 5 seconds while the Pulse Width will
decrease by 70% in the next 5 seconds and vice-versa. The total cycle
time is 10 seconds. Pulse Rate and Pulse Width are fully adjustable.
4.3 Technical Specifications (EMS)
Modes (3) S (Synchronous) and A (Alternate)
Synchro-
nous Mode
(S)
Stimulation of two channels occurs synchronously. The “ON” time
includes “Ramp Up” and “Ramp Down” time. Therefore, the setting
of “ON” time must be at least 2 x the value set for “Ramp” time. Ex: If
“Ramp” set to 8 seconds, “ON” time must be at least 16 seconds.
Alternate
Mode (A)
Stimulation of CH2 will occur after CH1 contraction is completed (same
applies for CH3 once CH4 contraction is complete). The setting of the
“ON” time must be at least 2 x the value set for the “Ramp” time and the
“OFF” time must be at least equal to the “ON” time. Ex: If “Ramp” set to 8
seconds, “ON” and “OFF” time must be at least 16 seconds.
Loading ...
Loading ...
Loading ...