Loading ...
Loading ...
Loading ...
9
When to Charge the iON+ 24VBAT
Lithium-iON Battery
NOTE: The iON+ 24VBAT lithium-iON battery pack does
not develop a "memory" when charged after only a partial
discharge. Therefore, it is not necessary to run down the
battery pack before inserting the charger plug.
• Use the battery indicator lights to determine when to charge
your iON+ 24VBAT lithium-iON battery pack.
• You can "top-o" your battery pack's charge before starting
a big job or after a long day of use.
Charging the Battery
1. Push the push lock buttons on the battery to pull the
battery pack out from the battery compartment (Fig. 1).
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, plug the
charger adapter into an appropriate AC power outlet.
Connect the charger plug into the charge socket of the
battery to start charging (Fig. 2).
3. The battery will take approximately 2 hrs 40 mins to
charge. The battery indicator LEDs will twinkle and
illuminate one by one during the charging process.
Unplug the charger immediately when the 3 LEDs are all
illuminated.
mCAUTION! FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet rst, then disconnect the charger from the battery.
mWARNING! This charger does not automatically
turnowhenthebatteryisfullycharged.Please take care
not to leave the battery plugged into the charger. Switch
oorunplugthechargeratthemainswhenchargingis
complete.
4. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
Assembly
mWARNING! To avoid serious personal injury, read and
understand all safety instructions provided.
mWARNING! Do not insert battery until assembly is
complete. Failure to comply could result in accidental starting
and possible serious personal injury.
mWARNING! Before performing any maintenance,
make sure battery is removed. Failure to heed this warning
could result in serious personal injury.
Adjust the Wheel Frame
NOTE: The patio cleaner comes with the wheel frame in
storage position. Follow the instructions below to set the wheel
frame in operation position.
1. Loosen the wheel frame knob, and rotate the wheel frame
assembly to the working position. Rotate the wheel frame
knob to lock the assembly (Fig. 3).
Fig. 1
Push lock button
Fig. 2
Battery
indicators
Loading ...
Loading ...
Loading ...