Loading ...
Loading ...
Loading ...
6. After cleaning, replace the infuser (A8) by
sliding it onto the internal support and pin at
the bottom, then push the PUSH symbol fully
in until it clicks into place.
NB!
If you encounter difficulty inserting the
infuser, before inserting
it you must adapt it to
the right dimension by
pressing it forcefully
from the bottom and top
as shown in the figure.
7. Once inserted, make
sure the two red but-
tons have snapped
out.
8. Replace the drip tray
(A11) and grounds
container (A9).
9. Close the service door (A12).
Cleaning the milk container
Important!
Always
clean the tubes inside the
milk container (B) when
you prepare milk. If there
is still milk in the contain-
er, do not leave it out of
the refrigerator for longer
than necessary. Clean the
container each time you
prepare milk as described
in the section "Cleaning
the milk container after
use".
1. Turn the lid of the
milk container clock-
wise then remove it.
2. Remove the milk spout and intake tube.
3. Remove the pointer by pulling it outwards.
4. Wash all the components thoroughly with hot
water and mild dish detergent. Make sure
there are no milk residues left inside the holes
and the groove on the fine end of the pointer.
5. Check that the
intake tube and
spout are not
clogged with
milk residues.
6. Replace the
pointer, milk
spout and intake tube.
7. Replace the milk container lid.
DESCALING
Descale the machine when the red light and the
message "DESCALE" flash on the display.
Important!
Descaler contains acids which
may irritate the skin and eyes. It is vital to respect
the manufacturer's safety warnings given on the
descaler pack and the warnings relating to the pro-
cedure to follow in the event of contact with the skin
and eyes.
NB!
Failure to descale the appliance as
described above voids the guarantee.
1. Press the P button to enter the menu;
2. Turn the selection knob until "Descaling" is
displayed;
3. Select by pressing the button. The
message "Descaling Confirm?" is displayed.
Press to activate the function.
4. If the message "INSERT WATER SPOUT" is
displayed, insert it (fig. 3).
5. The message "Insert Descaler. Confirm?" is
displayed.
6. Empty the water tank (A7).
7. Pour the descaler diluted with water (respect-
ing the proportions indicated on the descaler
bottle) into the water tank. Always use
descaler recommended by De’Longhi (contact
an authorized customer service center).
8. Place an empty container with a minimum
capacity of 50 oz under the hot water spout
(B7) (fig. 3).
18
Hole
Hole
Pin
Support
spout
milk intake
tube
Groove
Pointer
Loading ...
Loading ...
Loading ...