Loading ...
Loading ...
Loading ...
Wind hitting the grill
while in use, especially
winds blowing into
or across this hood
gap, can cause poor
performance and in
some cases can cause
the control panel to
get dangerously hot.
Figure 3-2
- Steady or gusty winds can prevent the normal exhaust of hot gases. Locate your grill
away from prevailing winds and avoid grilling in windy conditions. If needed, install the wind bae
SPECIAL NOTE FOR LP USE
Never connect any unregulated
gas supply to the grill. The hose
with regulator and Type 1 con-
nection included with your grill
has these safety features:
• The system will not allow gas to
ow until a positive connection
has been made.
•The system has a thermal ele-
ment that will shut-o the ow
of gas between 115 and 150ºC
(240 and 300ºF).
• The system has a ow limiting
device which, when activated,
will restrict the ow of gas to 10
cubic feet per hour.
NOTE: The cylinder control valve
must be turned o before any
connection is made or removed.
NEVER USE GRILL WITHOUT
FIRST LEAK TESTING THIS
CONNECTION, FOLLOWING
THE PROCEDURE ON PAGE 11.
Should the large, black, ther-
mally sensitive coupling nut be
exposed to temperatures above
115-150ºC, it will soften, allow-
ing the regulator probe to dis-
engage from the cylinder valve,
thereby shutting o the ow of
gas. Should this occur, do not
attempt to reconnect the nut.
Remove the entire regulator as-
sembly and replace it with a new
one. The cause of the excessive
heat should be determined and
corrected before operating your
grill again. The regulator probe
also contains a ow-sensing el-
ement, which will limit the ow
of gas to the regulator to a man-
ageable amount in the event of
a hose or regulator rupture. If it
is evident that the ow control
device has activated, the cause
of the excess ow should be de-
termined and corrected before
using your grill again.
NOTE: Improper lighting proce-
dures can cause the ow control
to activate, resulting in reduced
heat output. If this is suspected,
to reset ow control, shut o
all burner controls and cylinder
valve, wait 30 seconds, then
turn cylinder valve on extremely
slowly, wait ve (5) seconds and
turn burner valve on to light.
Figure 3-1
- The included hose
and regulator must be used if
your grill is set-up for LP Gas.
3
Loading ...
Loading ...
Loading ...