Loading ...
Loading ...
Loading ...
17
EN
Water filling
Filling the water tank
All functions require the water tank to be full.
Fill the water tank up to the “MAX” mark with cold,
fresh drinking water (approximately 4 cups/ 1L)
and introduce it into the slot located above the
cavity.
If the indication “rES” appears, it means that the
water tank was not properly inserted.
Water level indication
The water tank level is indicated in four levels:
“-L0-“ 0%-20%
“-L1-“20%-60%
“-L2-“60%-100%
These indications are shown in the leftmost
display.
Remark: To fill up take the water tank
completely off. Wait approximately >
20seconds before reinstate the full water tank.
Refilling the water
The contents of the water tank normally suffice for
one cooking session of 50-60 minutes.
If, however, the water tank needs to be refilled this
is signalled by the message “- L0 -” meaning that
the water tank is empty.
Warning! Only fill the water tank up to a
maximum of 2 cups to ensure that the water
does not overflow when it is pumped back to
the water tank. RISK OF OVERFLOW.
Water tank message
When the water tank is removed or misplaced, the
Water Level display shows the message “RES”.
To clear the message, correctly insert the water
tank.
Emptying the water tank
When the appliance is switched off, the residual
water is pumped back into the water tank.
While the water is being pumped the display shows
“PUMP”.
This message stays on until the temperature of the
water reaches 167º F before it can be pumped
back to the water tank.
Warning: the water in the tank may be hot.
Danger of burns!
After the water is pumped back to the water tank,
the display will show the message “DEP” requiring
the following actions:
1. Remove and empty the water tank.
2. Dry the water tank and introduce it back into
the slot located above the cavity. Clean and
dry the cooking space.
3. Leave the appliance door open so that the
cooking space can cool down and dry
completely.
IMPORTANT NOTE: It is advisable to remove
the water tank and empty it after a cooking
cycle. This prevents the formation of bacteria
and limestone inside the appliance.
If the water tank has not been removed from the
oven and a new cooking cycle is started, the oven
displays the warning “DEP”.
This warning can be cleared by pressing the Stop
key and proceed with the new cooking cycle
without removing and emptying the water tank.
Loading ...
Loading ...
Loading ...