Loading ...
Loading ...
Loading ...
17
NOTE: The 2 bolts located on the left have 2 nuts on the back,
while the other 4 bolts don't. Use one 10 mm wrench to hold
the left two bolts steady and remove the nuts with the other 10
mm wrench rst, and then remove all the bolts.
3. Use the needle nose pliers to remove the spring from the
hook to release the belt tension (Fig. 26).
4. Remove the drive belt by slowly turning the auger pulley
counterclockwise while pulling the belt outwards (Fig. 27).
5. Install the new drive belt, rotating it onto the pulleys
(Fig. 28).
NOTE: Rotate the new drive belt rst around the engine pulley,
then the idle pulley, and nally around the auger pulley. Slowly
turn the auger pulley clockwise to drive the belt inwards
(Fig. 29).
6. Use needle nose pliers to reinstall the spring onto the
hook to tension the belt. Replace the side panel on the
unit, secure with the original hardware. The snow blower is
ready to use.
Storage
1. Examine the cordless snow blower thoroughly for worn,
loose or damaged parts. Should you need to repair or
replace a part, contact an authorized Snow Joe
®
+
Sun Joe
®
dealer or call the Snow Joe
®
+ Sun Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563) for assistance.
2. Clean the snow blower before storing or transporting.
Be sure to secure the unit while transporting.
3. Remove the battery pack from the cordless snow blower
before storing.
4. Store the cordless snow blower indoors in a locked, dry
place out of the reach of children to prevent unauthorized
use or damage.
Fig. 25
Right side
panel
Bolts
Nuts
Old belt
Fig. 26
Needle nose
pliers
Spring
Fig. 27
Drive belt
Auger pulley
Fig. 28
New drive
belt
Fig. 29
Spring
Spring hook
Engine
pulley
Idle pulley
Auger pulley
Belt
Loading ...
Loading ...
Loading ...