Loading ...
Loading ...
Loading ...
80
3. After the scanner has been connected successfully, launch your
TWAIN-compliant image-editing software application to start a scan.
Note:
The network scanner can be used by one user at a time. If the network scanner is
being used by other user, you will be prompted with a message to connect the
scanner later. When the scanner is available, you will also be prompted with a
message to connect the scanner and start scanning your document.
If the network scanner has not been found, it is probably the scanner and your
computer are not in the same LAN. In this case, you can assign a specific IP
address of the scanner to let [Virtual Scanner Link] automatically search the
scanner. Click the [Option] button, type your IP address on the [Searching
Address] field (1), then click the [+] button (2) and finally click [OK] (3) to
complete.
Searching Time: When the program is launched, it automatically searches the
scanner in the network in 5 seconds (default). The searching time can be changed
from a range of 5 to 20 seconds.
If the [Virtual Scanner Link] program has been closed and then launched again,
[Virtual Scanner Link] will automatically search and connect the network scanner
it has previously connected to.
The connection is always enabled, whether the scanner enters into the sleeping mode
or turns off and on again. VSL will automatically detect the previously connected
scanner and connect again.
(1)
(2)
(3)
Loading ...
Loading ...
Loading ...