Loading ...
Loading ...
Loading ...
14 | English
That the declared vibration total value(s) and the declared
noise emission value(s) may also be used in a preliminary as-
sessment of exposure.
That the vibration and noise emissions during actual use of
the power tool can differ from the declared values depend-
ing on the ways in which the tool is used especially what kind
of workpiece is processed; and of the need to identify safety
measures to protect the operator that are based on an estim-
ation of the exposure measures in the actual conditions of
use (taking account of all parts of the operating cycle such as
the times when the tool is switched off and when it is running
idle in addition to the trigger time).
Noise emission values determined according to EN
62841-4-2:2019.
Typically the A-weighted noise levels of the product are:
Sound pressure level 75dB(A); sound power level
95dB(A). Uncertainty K=2.0dB.
Wear hearing protection!
Vibration total values a
h
(triax vector sum) and uncertainty K
determined according to EN 62841-4-2:2019:
a
h
= 2.5 m/s
2
, K = 1.5 m/s
2
.
Operation
u Pay attention to the mains voltage. The voltage of the
power source must match the voltage specified on the
rating plate of the machine.
Switching ON/OFF (see figures C and D)
To switch ON, firstly press and hold the lock-off button for
On/Off switch (3). Then press the On/Off switch (2) and
keep it pressed.
To switch OFF, release the lock-off button for On/Off switch
(3) and then release the On/Off switch (2).
Sawing Function
Although the tooth opening allows wood to be cut up to
Ø20mm, the tip of the blade is designed to cut wood up to
Ø25mm.
Working with the Hedgecutter (see figure E)
Move the hedgecutter evenly forward along the cutting line.
The double edge cutting blade enables cutting in either dir-
ection, or with a side to side motion.
Cut the sides of the hedge first, then the top.
To cut the sides straightly, we recommend cutting from bot-
tom to top in the direction of growth. Younger stems tend to
move outwards when cutting them from top to bottom, res-
ulting in shallow patches or holes in the hedge.
To reach a level finish, fasten a piece of string along the
length of the hedge at the required height and use as an
alignment guide. Cut the hedge just above the string.
Pay attention that no objects such as wires are cut. The
blade or drive can be damaged.
Troubleshooting
Problem Possible Cause Corrective Action
Hedgecutter does not
operate
Power turned off Turn power on
Mains socket faulty Use another socket
Mains cable damaged Check mains cable; if damaged, contact Service
Agent
Extension cable damaged Inspect extension cable, replace if damaged
Fuse faulty / blown Replace fuse
Hedgecutter operates
intermittently
Internal wiring of garden tool defective Contact Service Agent.
On/Off switch defective Contact Service Agent.
Motor runs but blades
remain stationary
Internal Error Contact Service Agent.
Cutting blade hot Cutting blade blunt Have blade sharpened
Cutting blade has dents Have blade inspected/overhauled
Too much friction, due to lack of lubricant Apply lubricant spray
Excessive vibrations/
noise
Machine defective Contact Service Agent.
F 016 L94 168 | (20.01.2021) Bosch Power Tools
Loading ...
Loading ...
Loading ...