Loading ...
Loading ...
Loading ...
en Positioning and connecting
42
Electrical connection
Electrical safety
:Warning
Risk of electric shock!
Danger of death if live parts are
touched.
■ When disconnecting the main plug,
always pull the plug itself and not the
cable, otherwise the cable could be
damaged.
■ Never touch or hold the mains plug
with wet hands.
■ Never pull out the mains plug during
operation.
■ Only connect the washer dryer to an
alternating current using a correctly
installed earthed socket.
■ The mains voltage must be the same
as the voltage specifications on the
washer dryer (appliance rating
plate).
■ The connected load and the required
fuse are also indicated on the
appliance rating plate.
Ensure that:
■ The mains plug and socket match.
■ The cable cross-section is adequate.
■ The earthing system has been
installed correctly.
■ A damaged power cord is only
replaced by an electrician.
A replacement mains cable can be
obtained from customer service.
■ You do not use multiple plugs/
couplings or extension cables.
■ If a residual-current-operated circuit
breaker is used, you use only a type
which features this symbol: z.
Only this symbol guarantees
compliance with the currently valid
regulations.
■ The mains plug is always accessible.
■ The power cord is not kinked,
crushed, altered or severed and has
not come into contact with any heat
sources.
Before washing/drying for the
first time
The washer dryer was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Drum Clean programme the first time
without laundry.
Note:
■ The washer dryer must have been
installed and connected properly.
Installation and connection
~ Page 37
■ Never switch on a damaged washer
dryer. Inform your customer
service.~ Page 35
1. Insert mains plug.
2. Turn the tap on.
3. Switch on the appliance.
4. Close the door. Do not load any
laundry.
5. Select the Drum Clean 40°C
programme.
6. Open the detergent drawer.
7. Pour approx. 1 litre of water into
dispenser II.
8. Add standard detergent to
dispenser II according
to manufacturer’s instructions for
light soiling.
Note: To prevent frothing, use only
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
9. Close the detergent drawer.
10.Select
A Start/Reload.
11.When the programme ends, switch
off the appliance.
Your washer dryer is now ready for
use.
Loading ...
Loading ...