Loading ...
Loading ...
Loading ...
en Operating the appliance
18
Notes
■ If there is a high water level, high
temperature or if the drum is
rotating, the door remains locked
for safety reasons and reloading is
not possible.
If the following is indicated on the
display panel:
Õ is lit ~ Reloading is not
possible. To continue the
programme, select the
A Start/
Reload button.
■ Do not open the door until the door
lock symbol Õ goes out.
■ Do not leave door open for
a prolonged period – water could
run out of the laundry.
■ The reloading function cannot be
activated during the drying phase.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1. Select
A Start/Reload.
2. Select another programme. If
required, adjust the default settings
and/or select additional functions.
3. Select
A Start/Reload. The new
programme starts from
the beginning.
Interrupting or ending the
programme
For programmes at high temperature:
1. Select
A Start/Reload.
2. To cool down laundry: Select Rinse
O.
3. Select
A Start/Reload.
For programmes at low temperature:
1. Select
A Start/Reload.
2. Select Spin/Drain 0/[.
3. Select
A Start/Reload.
For drying programmes:
1. Select Intensive dry 5 or Gentle
dry ‰.
2. Touch button Š Dry and set drying
time to 15 minutes.
3. Select
A Start/Reload.
End of the programme
End or – – – – (Rinse stop = without
final drain/spin cycle) is indicated in the
display and acoustic signal sounds.
Setting the signal ~ Page 27
If – – – – (Rinse stop = without final
drain/spin cycle) was selected, press
A Start/Reload button to start the final
drain/spin cycle.
Notes
■ The programme continues by
pumping out the water and spinning
the laundry (the standard spin speed
can be changed beforehand).
■ If only the water is to be pumped out,
approx. 1 minute after the
programme starts, touch the
A
Start/Reload button before the spin
cycle starts. The programme is
interrupted and the door lock is
released. The laundry can be
removed.
■ If Hot flashes in the display before
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
■ Wrinkle guard process starts after
drying process is finished to prevent
laundry getting wrinkle if you do not
take laundry out in time. The process
lasts about 30 minutes. 0:00 will be
displayed in time display and o
symbol will be displayed as the
status symbol. You can press any
button or rotate the programme
selector to another position to
terminate this process, then the door
will be released and laundry can be
taken out.
Loading ...
Loading ...
Loading ...