Loading ...
Loading ...
Loading ...
Faults and what to do about them en
31
3 Faults and what to do
about them
Faults and what to do about them
Emergency release, e.g. if a
power failure occurs
e.g. in the event of a power cut
The programme will continue running
when the power supply has been
restored.
However, if the laundry has to be
removed, the washer dryer door can be
opened as follows:
:Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with detergent
solution and laundry.
If possible, leave it to cool down.
:Warning
Risk of injury!
You may injure your hands if you reach
into the drum while it is turning.
Do not reach into the drum when it is
turning.
Wait until the drum has stopped turning.
Caution!
Water damage
Any escaping water may cause water
damage.
Do not open the washer dryer door if
water can be seen through the glass.
1. Switch off the appliance. Disconnect
the mains plug.
2. Drain the detergent solution
.
3. Pull the emergency release
downwards with a tool and release.
The washer dryer door can then be
opened.
Information on the display panel
Information Cause/Remedy
Õ ■ Flashes fast + signal: The door was opened and the water level is too high.
Close the door, continue the programme with
A Start/Reload button or
select Drain [ programme.
■ Flashes slowly: The door lock temperature is too high to open the door. Wait
approx. 30 seconds until the door lock cools down.
Hot The door cannot be opened after the drying programme due to the high tempera-
ture. The cooling process continues until the display disappears, after which the
door can be opened.
r
■ Flashes (no water supply): Tap turned on? Water inlet filter blocked? Clean
the water inlet filter. ~ Page 30
Water hose kinked or blocked?
■ Lights up (low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
Loading ...
Loading ...
Loading ...