Loading ...
Loading ...
Loading ...
34
Setting Oven Controls
Setting Self Clean (cont’d.)
As soon as Self Clean becomes active, a motor driven lock
mechanism will begin locking the oven door automatically. door
Loc will appear in the display (Figure 51). DO NOT open the
oven door when door Loc is displayed (allow 15 seconds for the
lock mechanism to lock the oven).
Once the oven door has locked, CLn will appear in the display
indicating Self Clean has started (Figure 52).
When Self Clean is finished
1. Cln message will turn off and Hot will appear in display
window (Figure 53).
2. Once the oven has cooled down (about 1 hour) and Hot is
no longer displayed, the door Opn message will appear
(Figure 54). When this message turns off the oven door may
be opened.
Use caution when opening the oven door after
self-cleaning. The oven may still be VERY HOT and can cause
burns. To avoid possible burns stand to the side of the oven
when opening the oven door to allow hot air or steam to escape.
3. When the oven interior has completely cooled, wipe away
any residue or powdered ash with a damp cloth or paper
towel.
Important note:
• The kitchen area should be well ventilated using an open
window, ventilation fan or exhaust hood during the 1st self-
clean cycle to help eliminate the normal odors associated
with the 1st self-clean cycle.
• When the clean time finishes the oven door will remain
locked until the range has cooled sufficiently. In addition to
the clean time that was programmed, you must allow about
1 additional hour for the oven to cool before you will be
able to open the oven door.
• The Self Clean function will not operate whenever a radiant
surface element is ON or the oven lockout is active.
Setting Delay Start Self Clean
To start a delay Self Clean with default clean time of 3 hours
and a start time of 9:00 o’clock:
1. Be sure the clock is set with the correct time of day, the oven
is empty and ALL oven racks are removed. Be sure oven
door is completely closed.
2. Press Delay Start.
3. Using numeric keypad enter 9 0 0.
4. Press to accept.
5. Press Self Clean.
6. Press .
If it becomes necessary to stop Self Clean when active:
1. Press .
2. If Self Clean has heated the oven to a high temperature,
allow enough time for the oven to cool and the door Opn
message to appear (Figure 54). When this message turns
OFF the oven may be opened.
3. Before restarting Self Clean, be sure to read important
notes below.
Important note:
• When Self Clean function is active you may check the
amount of clean time remaining by pressing Self Clean
once.
• If your control is set with the default 12 hour display mode,
the Delay Self Clean can only be set to start up to 11 hours
and 59 minutes in advance. To set a Delay Start Self Clean
to begin 12 or more hours (maximum is 23 hours and 59
minutes) in advance, be sure to set the control for 24 hour
display mode.
• If Self Clean was active and then interrupted by a power
failure or cancelled before the oven was thoroughly
cleaned, it may be necessary to run another self-clean cycle
again. If the oven temperature was high enough when inter-
rupted your oven control may not allow another self-clean
cycle to be set for up to 4 hours after the interruption.
Figure 51: Door locking Figure 52: Oven in clean mode
Figure 53: Oven too hot for
door to unlock
Figure 54: Door opens when
oven has cooled
Loading ...
Loading ...
Loading ...