Loading ...
Loading ...
Loading ...
Note: When the product cuts grass in the
secondary area, the
Secondary area
mode
must be selected. Refer to
2nd area on page
28
.
3.3.4 To examine where to put the guide
wire
• Put the guide wire in a line at a minimum of
1 m / 3.3 ft. in front of the charging station.
Min 1m / 3.3ft
G
• Make sure that the guide wire has as much
free area as possible to the left of the guide
wire when facing the charging station. Refer
to
Guide calibration on page 21
.
• Put the guide wire minimum 30 cm / 12 in.
from the boundary wire.
• Do not make sharp bends when you install
the guide wire.
• If the work area has a slope, put the guide
wire diagonally across the slope.
3.3.5 Work area examples
B
D
A
C
• If the charging station is put in a small area
(A), make sure that the distance to the
boundary wire is at a minimum 2 m / 6.6 ft.
• If the work area has a passage (B), make
sure that the distance to the boundary wire
is at a minimum 2 m / 6.5 ft. If the passage is
smaller than 2 m / 6.5 ft., install a guide wire
through the passage. Minimum passage
between the boundary wire is 60 cm / 24 in.
• If the work area has areas which are
connected by a narrow passage (B), you
can set the product to leave the guide wire
after a certain distance (C). The settings can
be changed in
Lawn Coverage
. Refer to
To
set the Lawn Coverage function on page
23
.
• If the work area includes a secondary area
(D), refer to
To make a secondary area on
page 17
. Put the product in the secondary
area and select
Secondary area mode
.
18 - Installation 982 - 003 -
Loading ...
Loading ...
Loading ...