Loading ...
Loading ...
Loading ...
2. Slide your washer into position.
6. Use a level to make sure that all four sides of your washer are level.
Plug the power cord into a well-grounded, 3-prong, 120 Volt 60 Hz
approved electrical outlet protected by a 12-amp fuse or comparable
circuit breaker. Your washer is grounded through the third prong of the
power cord.
5. Press the four corners again to make sure that your washer is level. If
your washer is still not level, repeat step 4.
4. Loosen the lock nut on the bottom of your washer, pull the leg down
until it touches the floor, then tighten the nut. Extend the feet only as
much as necessary. If the feet are extended too much, your washer
may vibrate.
3. Press the four top corners of your washer. If your washer moves when
you press a corner, the leg for that corner needs to be adjusted.
23
Power on
Safety
Instructions
Features
Operation
Requirements
Installation
Instructions
Washer Use
Washer Care
Troubleshooting
Loading ...
Loading ...
Loading ...