Loading ...
Loading ...
Loading ...
36
ELECTRONIC CONTROL SET-UP INSTRUCTIONS
NOTE: After the washer/dryer has been installed and plugged
in, the display will show “0 MINUTES” on the washer and
dryer portions of the display. After the washer and dryer doors
have been opened and closed, the display will show the price
for both the washer and dryer. On washer/dryers set for free
cycles, the display sections will ash “SELECT CYCLE.”
1. With a coin drop attached: Insert coins until “SELECT
CYCLE” ashes on the display portion of the washer
or dryer that is to be run.
Alternately, Generation 1 or 2 debit card systems may be
used; however, when the Generation 2 debit system is used,
the controls will automatically be set to Enhanced Debit
mode (J. Ed). In Enhanced Debit mode, the card balance will
also display when a debit card is inserted into the reader.
2. Door must be closed on the desired washer/dryer before
cycle selection is made.
3. Press the fabric setting button for the washer/dryer cycle
desired. For washer cycles, also select the desired wash
temperature. After the cycle is started, the time will display
and count down.
4. If a cycle is interrupted by opening the door or power loss,
“RESELECT CYCLE” will ash in the display. To restart the
washer/dryer, close door and reselect desired cycle.
NOTE: When set for free vend operation, an ongoing dryer
cycle will cancel if the door is opened.
Dryer control
Washer control
General Washer/Dryer User Information
SCROLLING “OUT OF ORDER” FOLLOWED BY
DIAGNOSTIC CODE SHOWING IN DISPLAY – This condition
indicates the washer or dryer is inoperative. Diagnostic codes
being displayed on the upper portion of the display pertain to
the dryer section, and diagnostic codes displayed on the lower
portion of the display apply to the washer section. Diagnostic
codes displayed on both the upper and lower portions of
the display pertain to the control system of both the washer
and dryer.
“0 MINUTES” SHOWING IN DISPLAY – This indicates the
cycle is complete and the washer/dryer cannot be operated.
Coins dropped or debit inputs during this condition will be
stored in escrow but cannot be used until normal operation is
restored by opening and closing the door. If a door switch has
failed, causing “0 MINUTES” to remain in the display after the
door is opened and closed, it must be replaced before normal
operation can be restored.
COLD START (Initial use) – Washer/dryer is programmed
at the factory as follows:
Washer 11 minute wash period
$2.00 wash price
3 rinses (extra rinse not enabled)
Dryer 5 minutes per quarter
$1.50 dry price (xed cycle with top off)
Loading ...
Loading ...
Loading ...