door frame
Make sure hole in door frame is drilled a
minimum of 1” (25 mm) deep.
Required tools
Ruler4 AA Batteries
Hammer
Wood
block
Pliers
Phillips screwdriver
Additional Tools (depending on application)
If drilling a new door, use the supplied template and the complete
door drilling instructions available at www.kwikset.com/doorprep
Note: Additional door preparation may be
required for doors with 11/2" (38 mm) holes.
Consult the deadbolt drilling instructions at
www.kwikset.com/doorprep
or
backset
Measure to conirm that the hole in
the door is either 21/8" (54 mm) or
11/2" (38 mm).
Measure to conirm that the backset is
either 23/8" or 23/4" (60 or 70 mm).
23/8" or 23/4"
60 or 70 mm
13/8" or 13/4"
35 mm or 44 mm
Measure to conirm that the hole in
the door edge is 1" (25 mm).
Measure to conirm that the
door is either 13/8" or 13/4"
(35 mm or 44 mm) thick.
A
A B C
D
B C D
21/8"
54 mm
11/2"
38 mm
1"
25 mm
1
Prepare the door and check dimensions
2
Install the latch and strike
Latch
Exterior Assembly
Interior Cover
Strike SmartKey Tool
A
E
J L M
F G H
B C D
Parts List
Drive-In Collar
Keys
Latch and
Strike Screws
Mounting Plate
Interior Assembly
Screws
Interior
Assembly
Mounting Plate
Screws
Align tabs with
holes in collar.
A
A
A
K (x2)
K (x2)
P (x2)
B
180°
Is the door edge chiseled?
Is the slotted hole centered in the door hole?
Hold the latch in front of the door hole, with
the latch face lush against the door edge.
YES
YES
NO
NO
Install latch in door with
supplied screws.
No adjustment is
required. Proceed
to next step.
slotted hole
is centered
slotted hole is
NOT centered
Rotate latch face as
shown to extend latch.
Install latch in door with
wood block and hammer.
Install strike on the door frame.
chiseled
not
chiseled
Make sure
slotted hole is at
bottom of latch.
Make sure
slotted hole is at
bottom of latch.
Ensure collar
snaps into place.
Pull collar to test
for tight it.
unlocked
C
A
K
P
N
or
or
1 / 4
66895
Rev 03
Installation and User Guide
Kwikset
Technical Support
1-800-327-5625
www.kwikset.com
ENGLISH
Use a lathead screwdriver to
lift tabs on collar of rectangular
face to remove it from latch.
Install drive-in collar.
IMPORTANT: Make sure the latch bolt is fully
retracted (in the unlocked position).
Loading ...
Loading ...
Loading ...
