Loading ...
Loading ...
Loading ...
30
Pressure Canning
31
Owner's Manual
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE RESOLUTION
Difculty closing lid. Silicone Gasket
may not be placed
correctly. Floater Valve
may be blocking the
push rod.
Place the Silicone Gasket
correctly. Push the Floater
Valve to the correct position.
Difculty opening lid. The Floater Valve
may not be falling
down properly.
Pot may be still
under pressure.
Push the Floater
Valve Correctly.
Gas leakage from
cooker lid.
Some ingredients
may get stuck to
the Silicone Gasket.
Silicone gasket may
be broken.
Clean the Silicone Gasket.
Make sure that the lid is close
see "Care and Maintenance"
Gas leakage from the
Floater Valve.
Some ingredients may
stick to the Floater
Valve’s sealing circle.
The Floater Valve’s
sealing circle may
be broken.
Clean the Anti-Clog Filter.
The Floater Valve’s sealing
circle may need to
be replaced.
Floater Valve does not
raise up.
There may not be
enough ingredients/
water to generate
enough pressure.
Gas leakage from
lid or Pressure
Release Valve.
Ingredients or water need to
be at minimum level.
Unit may need to be sent
to the manufacturer.
Pressure not
building up
The lid is not properly
locked in place.
Take the Lid off and retry.
Hold Lid, lower it, and turn
clockwise to lock. LED panel
will light up and display that
Sure Lock™ Safety Feature is
activated. Pressure will start
building up after that.
If the unit needs to be replaced or returned to the manufacturer,
please contact our Customer Service Department at:
1-877-689-2838 • help@nuwavenow.com
TROUBLESHOOTING (Continued)
Contact Customer Service if the pressure cooker displays
any of these error codes:
Code
Error
E1 E2 E3 E4
Sensor circuit
is broken
Circuit short Overheat
Signal switch
is broken
WARNING
Please immediately unplug and contact Customer Service
Department if you experience other problems.
1-877-689-2838 or help@nuwavenow.com
Loading ...
Loading ...
Loading ...