KCS08A10A User Manual

Loading ...

34 35

Figure 65

FRR021

Standard Window Installation continued

STEP 10. INSTALL THE R1 INSULATION PANEL – To minimize air

leaks and ensure optimal insulation, install the included R1

insulation panel (14 in parts list) (see Figure 67A-C).

First, measure the width from one side of the cabinet/ sleeve

(covering the side angles where the wingboard was just secured)

to the end of the wingboard (see Figure 67A).

Next, cut the R1 insulation panel to the measured width and

remove protective cover, exposing adhesive on back panel

(see Figure 67B).

Last, evenly apply the adhesive side of the panel across the

entire height and width from side angle to wingboard panel

(see Figure 67C).

Repeat the steps above for the other wingboard panel.

STEP 11. INSTALL THE WINDOW SEALING GASKETS – Measure

and cut the dark foam window seal gasket (Item 12) and

install it between the upper glass panel and the top part of

the window sash (see Figure 67A).

STEP 12. Carefully team lift the chassis and set it into the cabinet. Slide

the chassis stopping approximately 3″ from full insertion. Insert

the chassis seal gasket (Item 13) one inch deep between the

chassis and the cabinet (see Figure 68) as shown on Page 37.

A paint stir stick or ruler might be helpful here. Begin inserting

the gasket at either bottom corner and go up the side, across the

top, and down the opposite side. Then push the chassis all the

way into the cabinet.

NOTE: If the chassis seal gasket is not installed or installed improperly,

the operation of the unit will be negatively affected. Operational

noise and outside noise will also amplied.

STEP 13. Reattach the EntryGard

™

chassis and EntryGard

™

retainer wire

with the same screw retained in Step 1 (see Figure 54).

CAUTION

Cut/Sever

Although great care has been

taken to minimize sharp edges

in the construction of your unit,

use gloves or other hand

protection when handling unit

Failure to do so can result in minor

to moderate personal injury.

WARNING

Falling Object Hazard

Not following Installation Instructions

for mounting your air conditioner can

result in property damage, injury, or

death.

ROTATED 90°

SPRING STEEL CLIP

(ITEM 10) 2 REQUIRED

SLIDE CLIP OVER CUT EDGE

OF WINGBOARD PANEL

CUT EDGE

CENTER THE HOLE IN THE

SPEED NUT OVER THE SLOT

IN THE WINGBOARD PANEL

CUT

WINGBOARD

PANEL

“J” TYPE SPEED NUT

(ITEM #9) 2 REQUIRED

3″

Loading ...

User Manual - Page 35