Loading ...
Loading ...
Loading ...
16
The descale programme automatically performs a series
of rinses and pauses to remove the limescale�
It is normal for several minutes of inactivity to elapse
between rinses�
After about 30 minutes, the water tank is empty and the
and lights ash� Turn the steam dial clockwise as far as it
will go to the 0 position�
The appliance is now ready for rinsing through with clean
water�
7� Empty the container used to collect the descaler solution
and replace it empty under the cappuccino maker�
8� Remove the water tank, empty, rinse under running
water, ll with clean water and replace� The light
ashes�
9� Turn the steam dial anticlockwise to the I position (g� 5)�
Hot water comes out of the spout�
10� When the water tank is completely empty, the light
ashes�
11� Turn the dial to the 0 position� The light goes
o�
Fill the water tank again and the machine is ready for use�
SETTING WATER HARDNESS
Descaling is necessary after a period of operation established
according to the water hardness set�
The machine is factory set for a hardness value of 4�
The machine can also be programmed according to the
hardness of the mains water in the various regions so that the
machine needs to be descaled less often�
Measuring water hardness
1. Remove the “TOTAL HARDNESS TEST” indicator paper
attached to this manual from its pack�
2� Immerse the paper completely in a glass of water for one
second�
3� Remove the paper from the water and shake lightly�
After about a minute, 1, 2, 3, or 4 red squares form,
depending on the hardness of the water� Each square
corresponds to one level�
Level 1
Level 2
Level3
Level 4
Set water hardness
1� Make sure the appliance is o (but connected to the
mains electricity supply and with the main switch in the I
position);
2� Press the button and hold it down for at least
6 seconds� The and lights come on
together;
3� Press the button (on the left of the dial) to set
the actual water hardness as measured by the indicator
paper�
Level Level Level Level
1 234
4� Press the button (on the right of the dial) to
conrm the selection�
The machine is now reprogrammed with the new water
hardness setting�
TECHNICAL SPECIFICATION
Voltage: 220-240 V~ 50/60 Hz max� 10A
Absorbed power: 1450W
Pressure: 15 bars
Water tank capacity: 1�8 litres max�
Size LxHxD: 238x340x430 mm
Cable length: 1�15 m
Weight: 9�1 kg
Coee beans container capacity: 250 g max�
The appliance complies with the following EC
directives:
• ECRegulation1275/2008forstandby;
• Low Voltage Directive 2006/95/EC and subsequent
amendments;
• EMC Directive 2004/108/EC and subsequent
amendments
• Materialsandaccessoriescomingintocontactwithfood
conform to EEC regulation 1935/2004�
Loading ...
Loading ...
Loading ...