Loading ...
Safety
WARNING:
Do not repair or replace any part of the appliance unless specifically recommended in the manuals. Improper installation,
service or maintenance can cause injury or property damage. Refer to this manual for guidance. All other servicing should be
done by a qualified technician.
Gas Appliance Safety
WARNING:
If the information in this manual is not followed exactly, a
fire or explosion may result causing property damage,
personal injury or death.
-- Do not store or use combustible materials,
gasoline or other flammable vapors and liquids
in the vicinity of this or any other appliance.
-- WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire
department.
-- Installation and service must be performed by a
qualified installer, authorized service agency or
the gas supplier.
• Install a gas shutoff valve near the appliance. It must be easily accessible in an emergency.
• Leak testing must be conducted by the installer according to the instructions in this manual.
• The appliance and its individual shutoff valve must bedisconnected from the gas supply piping system during any
pressure testing at pressures in excess of psi(3.5 kPa).
• The appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve during
any pressure testing of the gas supply piping system at test pressures equal to or less than psi (3.5 kPa)
• The minimum supply pressure must be 1” water column above the manifold pressure printed on the data plate.
• The maximum supply pressure must not exceed 14.0 inches water column (34.9Millibars).
• For Massachusetts installations:
• Installation must be performed by a qualified or licensed contractor, plumber or gas fitter qualified or licensed by
the state, province or region where this appliance is being installed.
• Shut-off valve must be a “T” handle gas cock.
• Flexible gas connector must be new and not longer than 36 inches
• Installer - show the owner where the gas shut-off valve is located.
Propane Gas (LP) Installation
• The propane (LP) gas tank must be equipped with its own high pressure regulator. In addition, the regulator supplied
with this unit must also be used.
• The appliance must be marked on the data plate on the back side of the appliance with: “Gas type: G31 LP”.
!
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE AFTER INSTALLATION IS COMPLETE.
IMPORTANT: SAVE FOR THE LOCAL INSPECTOR’S USE.
Loading ...
Loading ...
Loading ...