WH1000XM3S User Manual

Loading ...

Hint

The above procedure is an example. For more details, refer to the operating instructions supplied with your computer.

If the computer was connected with the headset the last time, an HFP/HSP connection is established when you turn on the

headset. Double-tap (gently touch it with your finger and immediately release it two times in rapid succession (interval of about

0.4 seconds)) the touch sensor control panel (middle of the right unit) while the headset power is turned on to switch to a music

playback connection (A2DP).

Note

When connecting, either [WH-1000XM3] or [LE_WH-1000XM3] or both are displayed on the connecting device. If both or [WH-

1000XM3] are displayed touch [WH-1000XM3], or touch [LE_WH-1000XM3] if [LE_WH-1000XM3] is displayed.

If the music playback sound quality is poor, check that the A2DP function which supports music playback connections is enabled

in the computer settings. For more details, refer to the operating instructions supplied with your computer.

If the last-connected Bluetooth device is placed near the headset, the headset may connect automatically to the device by simply

turning on the headset. In that case, deactivate the Bluetooth function on the device or turn off the power.

If you cannot connect your computer to the headset, delete the headset pairing information on your computer and perform the

pairing again. As for the operations on your computer, refer to the operating instructions supplied with your computer.

User Manual - Page 60