Loading ...
Loading ...
Loading ...
8
Moving the appliance by the gas line or door
handle
Do not move the appliance while holding the gas line; the gas
pipe could be damaged. There is a risk of a gas leak! Do not
move the appliance while holding it by the door handle. The
door hinges and door handle could be damaged.
Electrical connection
Caution!
Have the appliance set up by your after-sales service. A 16 A
fuse is required for connection. The appliance is designed for
operation at 220-240 V.
If the electricity supply drops below 180 V, the electrical
ignition system does not work.
Any damage arising from the appliance being connected
incorrectly will invalidate the guarantee.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.
For the after-sales service
Caution!
The appliance must be connected in accordance with the
data on the rating plate.
Only connect the appliance to an electrical connection that
meets the applicable provisions. The socket must be easily
accessible so that you can disconnect the appliance from the
electricity supply if necessary.
Please ensure the availability of a multi-pin disconnecting
system.
Never use extension cables or multiple plugs.
For safety reasons, this appliance must only be connected to
an earthed connection. If the safety earth terminal does not
comply with regulations, safety against electrical hazards is
not guaranteed.
An all-pole isolating switch with a contact gap of at least
3 mm must be present in the installation circuit. This is not
necessary if the appliance is connected by a plug that is
accessible to the user.
Electrical safety: The cooker corresponds to safety class I
and may only be used in conjunction with a safety earth
terminal.
You must use a H 05 W-F type cable or equivalent for the
appliance connection.
The mains voltage must correspond to the voltage specified on
the rating plate.
Caution!
All appliances with a three-wire cable must be earthed.
Connect the wires in the power cord according to the colour
coding:
Note: If the power cord is replaced
Only connect it to the appliance as shown in the connection
diagram.
Levelling the cooker
Always place the cooker directly on the floor.
The cooker has height-adjustable feet. This allows you to raise
the plinth by about 15 mm. Please observe the special
installation instructions.
Wall fixing
To prevent the cooker from tipping over, you must fix it to the
wall at the chain and with the protection angle. Please observe
the installation instructions for fixing the oven to the wall.
Setting up the appliance
The appliance must be set up directly on the kitchen floor
and in line with the specified dimensions. The appliance must
not be set up on any other object.
The distance between the top edge of the oven and the
bottom edge of the extractor hood must meet the
requirements of the extractor hood manufacturer.
Ensure that the appliance is not moved again after set up.
The distance from the high output burner or wok burner to
the fronts of the adjacent units or the wall must be at least 50
mm.
Appliance height (in mm): 900 mm
Appliance width (in mm): 600 mm
Appliance depth (in mm): 600 mm
Measures to be noted during transport
Secure all mobile parts in and on the appliance using an
adhesive tape that can be removed without leaving any traces.
Push all accessories (e.g. baking tray) into the corresponding
slots with cardboard at the edges, in order to avoid damaging
the appliance. Place cardboard or similar between the front and
rear side to prevent knocks against the inside of the glass door.
Secure the door and, if available, the top cover to the appliance
sides using adhesive tape.
Keep the original appliance packaging. Only transport the
appliance in the original packaging. Observe the transport
arrows on the packaging.
If the original packaging is no longer available
pack the appliance in protective packaging to guarantee
sufficient protection against any transport damage.
Transport the appliance in an upright position. Do not hold the
appliance by the door handle or the connections on the rear, as
these could be damaged. Do not place any heavy objects on
the appliance.
Explanaions
Green and yellow
earth wire
<
Blue (null) neutral wire
Brown phase (external conductor)


0LQ

Loading ...
Loading ...
Loading ...