Loading ...
Loading ...
Loading ...
21
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
Removal
1. Detach the oven door and lay it on a cloth with the handle
facing down.
2. Pull off the cover at the top of the oven door. Press in the
tabs on the left and right using your fingers (fig. A).
3. Lift the top panel up and pull it out (fig. B).
4. Lift the panel up and pull it out (fig. C).
Clean the panels with glass cleaner and a soft cloth.
: Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left.
1. Insert the panel at an angle towards the back (fig. A).
2. Insert the top panel at an angle towards the back into the
brackets. The smooth surface must face outwards. (fig. B).
3. Put the cover back in place and press on it.
4. Attach the oven door.
Do not use the oven again until the panels have been
correctly installed.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish doesn't turn out as well as you had hoped, refer to the
section Tested for you in our cooking studio, where you will
find plenty of cooking tips and tricks.
: Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Error messages
When the display panel shows an error message with
“, press
the
0 button. The message will disappear. The set time
function will be deleted. If the error message does not
disappear, call the Technical Assistance Service.
The following error messages can be solved by the user.
: Risk of electric shock.!
Incorrect repairs can be dangerous. Repairs may only be
carried out by qualified personnel from the Technical
Assistance Service.
%$
&
%
$
Problem Possible cause Remedy/information
The oven does
not work.
The circuit
breaker is
defective.
Look in the fuse box and
check that the circuit
breaker is in working order.
Power cut Check whether the kitchen
light or other kitchen appli-
ances are working.
The clock dis-
play flashes.
Power cut Reset the clock.
The oven does
not heat up.
There is dust on
the contacts.
Turn the control knobs back
and forth several times.
The gas burner
does not ignite.
Power failure or
damp ignition
plugs.
Light the gas burner with a
gas lighter or a match.
Error message Possible cause Solution/advice
“‹‚‚
A button has
been pressed
for too long or
has got stuck.
Press all of the buttons one
by one. Check if any button
is stuck, covered or dirty.
Loading ...
Loading ...
Loading ...