Loading ...
Loading ...
Loading ...
23
461308300_000 12/2013








 
 

20
ELECTRICAL CONNECTION
The electrical connection must be carried out in
accordance with the current standards and laws in
force.
WARNING:
IF THE SUPPLY CORD IS DAMAGED, IT MUST
BE REPLACED BY THE MANUFACTURER, ITS
SERVICE AGENT OR SIMILARLY QUALIFIED
PERSONS IN ORDER TO AVOID A HAZARD.
Before connecting check that:
The system and electrical sockets amperage is
adequate for the appliance maximum power (see
data label afxed on the back of the cooker).
The socket or system has an effective earth
connection in accordance with current standards
and prescriptions of the law. All responsibility is
disclaimed if this is not complied with.
The plug and socket or the multipolar switch must
be accessible after installation of the appliance.
• If the appliance has no power cable, connect one
with a suitable cross section to the terminal board
(see paragraph «CONNECTING THE POWER
CABLE»).
When connecting to the mains with a socket:
Fit to the power cable (if without) a standardized
plug, suitable for the load which is indicated on the
data label. Connect the wires making sure they
correspond as shown below, and remember that
the earth wire must be longer than the phase
wires:
letter L (phase) = brown wire
letter N (neutral) = blue wire
symbol
(earth) = green/yellow wire
The power cable must be laid so that no parts of it
ever reach a temperature of 75 °C.
For connecting do not use, adapters or shunts
as they could cause false contacts resulting in
INSTRUCTIONS FOR THE INSTALLER
hazardous overheating.
When connecting directly to the mains:
If the appliance is not tted with a supply cord
and a plug, or with other means for disconnection
from the supply mains having a contact separation
in all poles that provide full disconnection under
overvoltage category III conditions, then a means
for disconnection must be incorporated in the xed
wiring in accordance with the wiring rules.
Install a multipolar switch that can withstand the
appliance load, with a minimum opening between
the contacts of 3 mm.
Remember that the earth wire must not be cut out
by the switch.
CONNECTING THE POWER CABLE
The combi cookers leave the factory ready for single-
phase power, but they can, with due modications, be
powered by three phase systems by following these
instructions:
Remove the rear panel from the cooker.
Move the connecting plates in the terminal board
according to the type of connection you want,
following the diagram in g. 20. You will also nd
this diagram afxed to the back of the cooker.
Connect the power cable, whose cross section must be
suitable (see table on <TECHNICAL FEATURES>
paragraph) keeping the earth wire longer than the phase
wires.
Secure the cable in the clamp and - t the rear panel in
place.
Loading ...
Loading ...
Loading ...