Loading ...
Loading ...
Loading ...
36
Locating the Filters
Your refrigerator is equipped with water
ltering system. The water lter system lters
all dispensed drinking water, as well as the
water used to produce ice.
Water Filter
The water lter is located at the top right side
of the fresh food compartment.
Ordering Replacement Filters
To order your replacement lters, please visit
our online store at www.frigidaire.com/store,
by calling toll-free at 1-800-599-7569, or by
visiting the dealer where you purchased your
refrigerator. Frigidaire recommends that you
order extra lters when you rst install your
refrigerator, and that you replace your lters at
least once every six months.
Here is the product number to request when
ordering:
PureSource Ultra II
TM
Water Filter
Part #EPTWFU01
Replacing the Water Filter
In general, you should change the water
lter every six months to ensure the highest
possible water quality. Water Filter Status
on the user interface prompts you to replace
the lter after a standard amount of water
(125 gallons/473 liters for PureSource
Ultra II
TM
)
has owed through the system.
If your refrigerator has not been used for a period
of time (during moving for example), change the
lter before reinstalling the refrigerator.
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certied for cyst reduction may be used on
disinfected waters that may contain lterable cysts.
Test & certication results:
• Rated Capacity - 125 gallons/473 liters for
PureSource Ultra II
TM
ice and water lter
• Rated service ow - .65 gallons per minute
• Operating Temp: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds
per square inch
• Recommended Minimum Operating
Pressure: 30 pounds per square inch
To replace your PureSource Ultra II
TM
water lter:
It is not necessary to turn the water supply off
to change the lter. Be ready to wipe up any
small amounts of water released during the
lter replacement.
1 Turn Off the ice maker power switch.
2 Remove the old lter by rotating it counter-
clockwise (to the left) 90 degrees to release it.
3 Slide the old lter cartridge straight out of
the housing and discard it.
4 Unpackage the new lter cartridge. Slide it
into the lter housing as far as it will go with
the grip end horizontal.
5 Push lightly inward on the lter while rotating
it clockwise (to the right). The lter will then
pull itself inward as it is rotated. Rotate the
lter 90 degrees until it stops and the grip
end is vertical. You may be able to feel a very
light click as the lter locks into place.
6 Press a drinking glass against the water
dispenser while checking for any leaks at
the lter housing. Any spurts and sputters
that occur as the system purges air out of
the dispenser system are normal.
7 Continue dispensing water for 3-4 minutes
or until 1.5 gallons of water has owed
through the system. You will likely need to
empty and rell your glass several times.
8 Turn On the ice maker.
9 Press and hold the Water Filter reset
button on the control panel for three
seconds. When the display changes from
Red to Green, the status has been reset.
The PureSource Ultra II
TM
ice and water lter system is
tested and certied to NSF/ANSI
Standards 43, 53 and 401 for the
reduction of claims specied on
the performance data sheet.
More about your Advanced
Water Filter
NOTE
When ordering your replacement lter,
please reorder the same lter type that is
currently in your refrigerator.
CHANGING THE FILTER
Filter Cartridge
Loading ...
Loading ...
Loading ...