Loading ...
Loading ...
Loading ...
17
IMPORTANT
Your refrigerator’s water supply system
includes several tubing lines, a water lter,
and a water valve. To ensure that your
water dispenser works properly, this system
must be completely lled with water when
your refrigerator is rst connected to the
household water supply line.
CONNECTING THE WATER SUPPLY
NOTE
These instructions do not cover after market
ice maker installation. Instructions in after
market ice maker kit should be used.
Figure 1
Plastic Water
Tubing to Ice
Maker Fill
Tube
Steel
Clamp
Brass
Compression
Nut
Ferrule
(Sleeve)
Copper
water line
Water Valve
Bracket
Valve Inlet
Water Valve
Copper water line
from household
water supply
(Include enough tubing in loop to allow
moving refrigerator out for cleaning.)
Steel
Clamp
Braided
Flexible
Stainless
Steel
Water Line
Water Valve
Bracket
Valve Inlet
Water Valve
6 ft (1.8 Meters) Braided flexible
stainless steel water line from
household water supply.
Plastic Water Tubing
to Ice Maker
Fill Tube
(Include enough tubing in loop to allow
moving refrigerator out for cleaning.)
Figure 2
5 With steel clamp and screw, secure water
supply line to rear panel of refrigerator as
shown.
6 Coil excess water supply line (copper
tubing only), about 2½ turns, behind
refrigerator as shown and arrange coils so
they do not vibrate or wear against any
other surface. Do not kink tubing.
7 Turn ON water supply at shutoff valve and
tighten any connections that leak.
8 Reconnect refrigerator to electrical power
source.
9 To turn ice maker on, lower wire signal
arm (freezer ice maker) or set the ice
maker’s On/Off power switch to the “On”
position (fresh food ice maker).
Loading ...
Loading ...
Loading ...