Loading ...
Loading ...
Loading ...
26
TROUBLESHOOTING GUIDE
PROBLEM CAUSES SOLUTIONS
Transmitter display is blank. Transmitter is Off.
Battery is dead.
Press the MODE button for 5 seconds.
Replace battery.
Can’t access all the desired stations on the
transmitter.
Maximum station number is set wrong. See “Changing the Maximum Station.”
Receiver doesn’t beep 4 times after
plugging it into the SmartPort
®
.
SmartPort is not connected properly.
Controller has no power.
Recheck SmartPort
®
wiring.
Check controller power.
Receiver won’t respond to Transmitter. Receiver and Transmitter addresses don’t match. Relearn address at Receiver.
Transmitter display stays on. Transmitter will turn off automatically. Wait approximately 5 minutes without pressing
any buttons. Transmitter will “fall asleep.”
“ERR” message in controller display when
controller is in the run position.
SmartPort
®
wiring leads have been extended
and are receiving electrical or radio interference.
Replace lengthened wire with shielded cable
to reduce radio interference. Use Hunter
SRR-SCWH. See “Extending Wiring on
SmartPort
®
Harness.”
Receiver does not receive signal from
remote held at close range.
Mismatch of addresses in transmitter and
receiver.
Reset address of receiver.
Remote has short range. Check for interference causes. See “Maximizing Operating Range.”
Loading ...
Loading ...
Loading ...