Loading ...
Loading ...
Loading ...
21
ACTIVATING A STATION WITH THE ROAM XL REMOTE SYSTEM
The ROAM XL System will allow you to remotely turn
on and off any station on your Hunter controller with
the press of a button. Once on, the station will run for
the run time you have designated in the transmitter.
To remotely activate a station or program:
1. Plug the receiver into a SmartPort
®
that is
connected to a powered controller. The receiver
will beep 4 times followed by a 8-second pause
and two beeps.
2. If your transmitter is not on (no display), wake it
up by pressing and holding any button until the
display appears. The Transmitter will start up, and
then display the active station.
3. Use the and buttons to display the
station you would like to start, or press the Mode
button once to display programs.
4. Press the button to start the station or program.
The Transmitter will display the Transmit icon .
If you are near the receiver, you will hear it beep
two times. The Transmitter display will alternate
between "On" and the selected Station or
Program. This indicates that the Receiver has
received the command.
5. Press the button to turn off ALL stations or
programs that are on, including stations or
programs that were turned on by the controller.
The display will show the Transmit icon and the
receiver will beep again twice. The Transmitter
display will alternate between "OFF" and the
selected Station or Program. The ROAM XL
System is designed to turn on one station at a time
(unless you activate a program). Therefore, turning
a station on while another station is operating will
cause the operating station to turn off (does not
apply to the I-Core or ACC).
Loading ...
Loading ...
Loading ...