Loading ...
Loading ...
Loading ...
51
ENGLISH
Before calling for service (cont.)
Solutions
Garments are not
uniformly damp
after Easy Iron
•
Number of garments or load
size not properly selected at the
beginning of the cycle.
• Select the correct number or garments or load size before
starting the cycle.
Water drips from
door during
Steam Cycle
• This is normal. • Condensation will normally form on the inside of the
dryer door during steam operation. Some condensation
may drip out the bottom of the door.
Steam is not
visible during
Steam Cycle
• This is normal. • Steam vapor is difficult to see when the door is closed.
However, condensation will normally form on the inside of
the dryer door if the steam system is operating normally.
Drum does not
turn during Steam
Cycle
• This is normal. • The drum is turned off so that the steam vapor remains in
the drum. The drum will normally turn for about 2 seconds
once a minute.
Cannot see steam
vapor at the
beginning of
cycle
• This is normal. • Steam is released at different stages of the cycle for each
option.
The display shows
• More Time button pressed. • This display indicates that the steam option has been set
for a “
” item such as a comforter.
Press the Less Time button to reduce the indicated load
size.
Odors remain in
clothing after
Steam Fresh™
• Steam Fresh™ did not remove
odor completely.
• Fabrics containing strong odors should be washed in a
normal cycle.
CHECK FILTER
light is on during
the drying cycle
• Lint filter is almost clogged or
full.
• Pause the drying cycle and clean the lint filter.
FLOW SENSE
TM
indicator shows
four bars during
the drying cycle
• Ductwork is too long or has too
many turns/restrictions.
• Significant blockage of the
ductwork due to lint buildup or
debris.
• The appliance has detected a
restriction in the external dryer
venting.
• Install a shorter or straighter duct run. See the Installation
Instructions.
• Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times may
be longer.
• If exhaust restrictions are sensed by the FLOW SENSE
TM
system, the indicator will remain on for two hours after
the end of the cycle. Opening the door or pressing the
POWER button will turn off the display.
Description Steam Dryer
Electrical Requirements* Please refer to the rating label regarding detailed information.
Dimensions 27” (W) X 30” (D) X 39” (H), 51” (D with door open)
68.6 cm (W) X 76.1 cm (D) X 99.1 cm (H), 129.7 cm (D with door open)
Net Weight 167.5lbs(76kg)
Drying Capacity
- Steam Cycle IEC 7.3 cu.ft. (8 lb/3.6 kg)
Allowable temperature 41°F~ 95°F(5°C ~ 35°C)
SPECIFICATIONS
TROUBLESHOOTING / SPECIFICATIONS
MFL67731031_en_170830.indd 51 2017.8.30 5:32:15 PM
Loading ...
Loading ...
Loading ...