Loading ...
Loading ...
Loading ...
5
4. Using the arrow pointing to the alignment pin on the side of
the filter and the arrow inside the control housing, align the
alignment pin with the cutout notch and insert the filter into the
housing.
A. Alignment pin
B. Unlocked
symbol
C. Locked symbol
D. Cutout notch inside control
housing
E. Arrow pointing to cutout
notch
F. Arrow pointing to alignment
pin
5. Turn the filter clockwise until it locks into the housing. Ensure
that the alignment arrow on the filter head aligns with the
locked symbol on the control box housing.
NOTE: If the filter is not correctly locked into the housing, the
ice maker will not produce ice.
A. Alignment arrow aligned with locked symbol
6. For 15" (38.1 cm) models, push the control box door closed
until the latch snaps closed.
Interior Cleaning
WARNING
Electrical Shock Hazard
Disconnect power before cleaning.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
Interior Components
1. Unplug ice maker or disconnect power.
2. Open the storage bin door and remove any ice that is in the
bin.
3. Remove the drain cap from the water pan and drain
thoroughly. Replace the drain cap securely on the water pan.
If the drain cap is loose, water will empty from the water pan,
and you will have either thin ice or no ice.
4. Pull out on the bottom of the cutter grid cover until the snaps
release to remove.
NOTE: On some models, remove the screw from the cutter
grid cover.
A. Cutter grid cover
B. Screw (on some models)
A. Cutter grid cover
5. Unplug the wiring harness from the left side of the cutter grid.
A. Cutter grid
harness
B. Screw
C. Cutter grid
D. Ice level sensor harness
E. Plastic spacer
F. Screw
6. Unplug the ice level sensor harness from the right side of the
cutter grid. Pull the ice level sensor down and forward away
from the cutter grid.
7. Remove the right-hand and left-hand screws. Lift the cutter
grid up and out.
NOTE: Make sure the plastic spacer from the right-hand side
of the cutter grid bracket stays with the cutter grid.
Loading ...
Loading ...
Loading ...