EN
Original Instructions
Version 1
April 2025
Read this leaet in full before using this product and retain
it for future use.
Intended Use
A fast acting and high strength adhesive for use where
good initial strength and fast development of full bonding
is required. Suitable for use on glass, wood, rubber, metal,
some hard plastics and most lightweight materials such
as paper, card and textiles.
NOT suitable for use on polystyrene and polyethylene/
polypropylene.
NOT recommended for use where the temperature will
regularly exceed 100°C.
Any other application beyond the conditions established for
use will be considered misuse. Draper Tools accepts no
responsibility for improper use of this product.
Direction for Use
1. Shake the can well before use.
2. Ensure all surfaces are clean, dry and free from grease.
3. Apply a thin uniform coat from a distance of 20 – 30cm.
− Lightweight materials – apply to only one surface.
− Heavier materials – apply to both surfaces and
leave for a minimum of 30 seconds before rmly
bonding together.
4. Position the two pieces of material accurately before
bonding together.
− It will take between 6 – 8 hours to cure and for full
bonding to occur.
− Once bonded together it will be dicult to separate
the materials.
Important: After spraying invert the can. Then spray for
2-3 seconds to clear the spray nozzle and valve.
Helpline: +44 (0) 23 8049 4344 Sales Desk: +44 (0) 23 8049 4333 General Enquiries: +44 (0) 23 8026 6355
Internet: drapertools.com Email: [email protected]
Draper Tools Limited, Hursley Road, Chandler’s Ford, Eastleigh, Hampshire. SO53 1YF UK.
Delta International, Delta International BV, Oude Graaf 8, 6002 NL, Weert, Netherlands. 0425
41918
HEAVY DUTY
ADHESIVE
