D GiDT
AGOT D1
tra Quardruped Robot
User Manual
DESCRIPTION OF PRODUCT Warning
FCC Warning
Any Changes expressly or modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the llowing two
conditions:
(l) This device may not cause harml interrence,and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits r a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interrence in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions,may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
llowing measures:
—Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit dierent om that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician r help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment .This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.This equipment should be installed and operated with minimum
distance 20cm between the radiator &you body
DESCRIPTION OF PRODUCT
06
DESCRIPTION OF PRODUCT Warnning
IC Warning
ISEDC RSS waing:
This device complies with Innovation, Science and Economic Development Canada Compliance
licence-exempt RSS standard (s). Operation is subject to the following two conditions:
(1) this device may not cause interrence, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le present appareil est confo1me aux CNR d'Innovation, Sciences et Developpement economique
Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisee aux deux
conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage
est susceptible d'en compromettre le nctionnement.
5250-5350MHz for indoor use only
5250-5350MHz pour l’usage d’intérieur seulement
ISEDC Ra
diation Exposure Statement:
This equipment complies with ISEDC RF radiation exposure limits set forth r an uncontrolled
e
nvironment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. This equipment should be installed and operated with minimum distance
20cm between the radiator& your body.
IC exposition aux radiations:
Cet equipement est conforme aux limites d'exposition aux rayonnements RF de l'isedc etablies pour
un environnement non contr6le.
Cet emetteur ne doit pas etre co-localises ou fonctionner en conjonction avec une autre antenne
ouemetteur.Cet equipement doit etre installe et utiliseavec une distance minimale de 20cm entre
l
eradiateur & votre corps.
DESCRIPTION OF PRODUCT
07
DESCRIPTION OF PRODUCT
08
DESCRIPTION OF PRODUCT Warnning
Other Warnings
The devices operating in the band 5150–5250 MHz shall only be used indoors to reduce the potential for
harmful interference to co-channel mobile satellite systems.
a)
any devices capable of operating in the band 5150-5250 MHz shall only be used indoors to reduce the
potential for harmful interference to co-channel mobile satellite systems (this requirement does not apply to
OEM devices installed in vehicles by vehicle manufacturers);
Les appareils fonctionnant dans la bande 5150-5250 MHz ne doivent être utilisés qu’à l’intérieur pour
réduire le risque d’interférence nuisible avec les systèmes satellites mobiles co-canaux
A) tout dispositif capable de fonctionner dans la bande 5150-5250 MHz ne doit être utilisé à l’intérieur que
pour réduire le risque d’interférence nuisible aux systèmes satellites mobiles co-canaux (cette exigence ne
s’applique pas aux dispositifs d’origine installés dans les véhicules par les fabricants de véhicules);
